Hot shrinking

Hot shrinking[1] is a process in car bodyworks.[2] As the name suggest heat will be involved, while "shrinking" is the process of straightening a metal section. This is a method of panel beating where a panel is first heated to make it softer. In most cases heating will be done by use of the oxyacetylene flame.

Hot shrinking process

Locate the highest point of the panel, light the torch and heat the spot to a cherry red. Strike the area using a mallet around the heat spot.after several blows the sop will turn black, quench it immediately with a damp cloth. Repeat the process around the heated spot until the stretched part became fully shrinked.[3]

See also

Cold shrinking - a longer but similar process

References
  1. "Shrinking Sheet Metal: Procedure". cid.vcc.ca. Retrieved 2017-04-29.
  2. Brownell, Tom. How to Restore Your Ford Pick-Up. MotorBooks International. ISBN 9781610590297.
  3. "Heat Shrinking Metal - Body Shop Business". Body Shop Business. 2006-02-01. Retrieved 2017-05-11.
This article is issued from Wikipedia. The text is licensed under Creative Commons - Attribution - Sharealike. Additional terms may apply for the media files.