Remote communications outlet

Remote communications outlets (RCO) are remote aviation band radio transceivers, established to extend the communication capabilities of Flight Information Centres (FIC) and flight service stations (FSS).

Pilots can find RCO frequencies in charts or publications such as the Chart Supplement or Canada Flight Supplement. The RCO is used to make a radio call to the outlet as if the pilot were making the call directly to the FSS or FIC. The outlet will relay the call (and the briefer's response) automatically. RCOs are sometimes confused with RTRs, or remote transmitter/receivers. In fact, the difference between the two is subtle. While RCOs serve flight service stations, RTRs serve terminal air traffic control facilities.

RCOs and RTRs may be UHF or VHF and are divided into a variety of classes determined by the number of transmitters or receivers. Classes A through G are used mainly for air/ground communications. Class O facilities were created specifically to provide ground-to-ground communication between air traffic controllers and pilots located at satellite airports. The idea was to create a way for pilots to receive en-route clearances or departure authorizations and cancel IFR flight plans. Class O RTRs also were intended to allow pilots flying below the coverage of the primary air/ground frequency to continue to receive advisories from air traffic control. Class O facilities are non-protected outlets and are subject to prolonged outages which may go undetected and unreported.

There is also a special variant of RCO which in Canada is called a Dial-up Remote Communications Outlet (DRCO) and in the U.S. is called a Ground communication outlet (GCO). DRCOs and GCOs connect to an FIC or FSS over a phone line, and pilots initiate the connection by keying their microphones in a prescribed pattern.

See also


This article is issued from Wikipedia. The text is licensed under Creative Commons - Attribution - Sharealike. Additional terms may apply for the media files.