SCCA RallyCross

SCCA RallyCross events are planned months in advance. A SCCA RallyCross must be run on a large open piece of ground free of hazardous debris such as large rocks and trees. Courses are laid out with pylons (cones) and typically are 30–90 seconds in time. Speeds don't see higher than highway speeds and going higher than 2nd gear is a rarity. Throughout the day of competition the surface quality is likely to change drastically as gravel or dirt is worn away and ruts are created and deepened or even as snow and ice melt. It is because of these requirements that finding a location for an event is sometimes the most difficult part of event planning. When a site is chosen and the appropriate paperwork (including sanctioning and insurance) is filled out the next step is site preparation. The site must be further prepared by removing debris and planning the course for race day.

On the day of the event the cones that will outline the course are laid out and any last minute adjustments are made. There are many jobs to be done during the competition itself. The organizers are responsible for assigning jobs to the appropriate people and seeing that they get done. Before any of the cars are allowed on course they must go through a technical-safety inspection which is handled by a tech inspector (also known as a scrutineer). This person must be familiar with how to check the safety of a vehicle (tech inspections do not check for car compliance). A group of people must also work in timing and scoring, keeping all the day's times straight. The last and most visible job is that of the corner worker. This position is almost always filled by the racers that are not racing during a given heat (round of competition). Corner workers are in charge of replacing knocked over cones and reporting the penalty to timing and scoring and in some cases may be required to tell a driver to stop in the case of an emergency.

Often the layout of the course will change throughout the day as the course must move away from dangerous ruts and other obstacles that are formed by the cars during competition. Each run made on the course could be drastically different than the last for a given driver. Instead of taking the best time out of a number of runs, the times for each run are summed together. Added to this time is an additional 2 seconds for every cone the car hit and 10 seconds for any gate that was missed. The winner is determined by the lowest combined time. RallyCross events have one car on course with no wheel to wheel or pass other cars. This process is similar to the timing for stage rally with individual runs over the same course instead of varying special stages.

This category is for cars that are nearly stock with very few upgrade allowances. A cat-back exhaust and the replacement of consumable items, such as tires and brake pads with street legal replacements, are allowed. The category is further broken down into:

Prepared is the category above Rally Stock. All Rally Stock modifications are allowed with the addition of more modification allowances to the suspension as well as the intake and exhaust. Any type and size of wheels and tires are allowed in this category. Prepared is broken down further into:

This category covers all vehicles not in the other two. In 2012 the former Modified 2WD class was split into Modified RWD and Modified FWD, though some regions still use the old M2 classing. Modifications are fairly unrestricted, allowing for any suspension (including any changes in suspension geometry) and the use of any internal combustion engine. Any log booked race car falls under this category. With these allowances this open class is the most competitive class in RallyCross. The category is divided into: