Adler-32

The Adler-32 checksum is part of the widely used zlib compression library, as both were developed by Mark Adler. A "rolling checksum" version of Adler-32 is used in the rsync utility.

An Adler-32 checksum is obtained by calculating two 16-bit checksums A and B and concatenating their bits into a 32-bit integer. A is the sum of all bytes in the stream plus one, and B is the sum of the individual values of A from each step.

At the beginning of an Adler-32 run, A is initialized to 1, B to 0. The sums are done modulo 65521 (the largest prime number smaller than 2¹⁶). The bytes are stored in network order (big endian), B occupying the two most significant bytes.

The function may be expressed as

A = 1 + D1 + D2 + ... + Dn (mod 65521)

B = (1 + D1) + (1 + D1 + D2) + ... + (1 + D1 + D2 + ... + Dn) (mod 65521)
  = n×D1 + (n−1)×D2 + (n−2)×D3 + ... + Dn + n (mod 65521)

Adler-32(D) = B × 65536 + A

where D is the string of bytes for which the checksum is to be calculated, and n is the length of D.

The Adler-32 sum of the ASCII string "Wikipedia" would be calculated as follows:

A =  920 =  0x398  (base 16)
B = 4582 = 0x11E6
Output = 0x11E6 << 16 + 0x398 = 0x11E60398

The modulo operation had no effect in this example, since none of the values reached 65521.

The first difference between the two algorithms is that Adler-32 sums are calculated modulo a prime number, whereas Fletcher sums are calculated modulo 2⁴−1, 2⁸−1, or 2¹⁶−1 (depending on the number of bits used), which are all composite numbers. Using a prime number makes it possible for Adler-32 to catch differences in certain combinations of bytes that Fletcher is unable to detect.

The second difference, which has the largest effect on the speed of the algorithm, is that the Adler sums are computed over 8-bit bytes rather than 16-bit words, resulting in twice the number of loop iterations. This results in the Adler-32 checksum taking between one-and-a-half to two times as long as Fletcher's checksum for 16-bit word aligned data. For byte-aligned data, Adler-32 is faster than a properly implemented Fletcher's checksum (e.g., one found in the Hierarchical Data Format).

In C, an inefficient but straightforward implementation is :

const uint32_t MOD_ADLER = 65521;

uint32_t adler32(unsigned char *data, size_t len) 
/* 
    where data is the location of the data in physical memory and 
    len is the length of the data in bytes 
*/
{
    uint32_t a = 1, b = 0;
    size_t index;
    
    // Process each byte of the data in order
    for (index = 0; index < len; ++index)
    {
        a = (a + data[index]) % MOD_ADLER;
        b = (b + a) % MOD_ADLER;
    }
    
    return (b << 16) | a;
}

See the zlib source code for a more efficient implementation that requires a fetch and two additions per byte, with the modulo operations deferred with two remainders computed every several thousand bytes, a technique first discovered for Fletcher checksums in 1988. js-adler32 provides a similar optimization, with the addition of a trick that delays computing the "15" in 65536 - 65521 so that modulos become faster: it can be shown that ((a >> 16) * 15 + (a & 65535)) % 65521 is equivalent to the naive accumulation.[3]

• Like the standard CRC-32, the Adler-32 checksum can be forged easily and is therefore unsafe for protecting against intentional modification.
• It's faster than CRC-32 on many platforms.[4]
• Adler-32 has a weakness for short messages with few hundred bytes, because the checksums for these messages have a poor coverage of the 32 available bits.

Adler-32 is weak for short messages because the sum A does not wrap. The maximum sum of a 128-byte message is 32640, which is below the value 65521 used by the modulo operation, meaning that roughly half of the output space is unused, and the distribution within the used part is nonuniform. An extended explanation can be found in RFC 3309, which mandates the use of CRC32C instead of Adler-32 for SCTP, the Stream Control Transmission Protocol.[5] Adler-32 has also been shown to be weak for small incremental changes,[6] and also weak for strings generated from a common prefix and consecutive numbers (like auto-generated label names by typical code generators).[7]

• List of hash functions

• RFC 1950 – specification, contains example C code
• ZLib – implements the Adler-32 checksum in adler32.c
• Chrome – uses an SIMD implementation of Adler-32 adler32_simd.c
• RFC 3309 – information about the short message weakness and related change to SCTP