Bicycle Torque Coupling
An S and S Coupling also known as a Bicycle Torque Coupling or BTC is a coupling which enables bicycle frames to be separated into smaller pieces, usually to facilitate packing and transporting. Couplings can be built into the frame by the frame manufacturer when the frame is made or can be added to a frame after it is finished. A special spanner is available for tightening and loosening the couplings.[1]
Applications
The couplings are usually installed in the top tube and down tube of a single-rider diamond frame. This enables the bicycle to be boxed small enough to avoid the extra fee most airlines charge to check a bicycle as luggage.[2] They can also be installed in tandem and recumbent frames. Santana manufactures a "triplet (or quad) that can be transformed into a tandem by simply removing the center section of the frame."[3]
Characteristics
The couplings are available in stainless steel, cromoly steel, and titanium and in different sizes, from 5/8 inch (15.8 mm) to 2 inches (50.8 mm) to match the frame tubing in which they are installed.[4] They weigh about 8 oz. (227 grams) per pair, and arc as strong as uncoupled tubing. They use a Hirth joint to resist torsion.
It takes a few minutes to separate the couplings.[5]
Alternatives
In order to support the ovalized tube Santana Cycles uses between the bottom bracket shells of their tandems, they have developed their own oval couplers.[6]
References
- "S and S Machine". Archived from the original on 20 October 2007. Retrieved 2007-10-19.
- "Size regulation for checked baggage". Archived from the original on 11 October 2007. Retrieved 2007-10-19.
- "Santana When two seats are not enough". Archived from the original on May 13, 2008. Retrieved 2007-10-19.
- "Stainless Steel "Classic" BTC Specifications". Archived from the original on 11 October 2007. Retrieved 2007-10-19.
- "S&S Couplers at Co-Motion". Archived from the original on 2011-06-15. Retrieved 2008-11-16.
- "Santana: The Oval Solution". Archived from the original on August 22, 2008. Retrieved 2007-10-19.
External links
- http://www.sandsmachine.com/ S and S Machine Bicycle Torque Couplings (BTCs)
- http://www.bikecad.ca/boxes Determining the placement of couplings in BikeCAD