Central Air Data Computer

The F-14's Central Air Data Computer (CADC) computes altitude, vertical speed, air speed, and mach number from sensor inputs such as pitot and static pressure and temperature.[1] Earlier air data computer systems were electromechanical computers, such as in the F-111.[2] From 1968 to 1970, the first CADC to use custom digital integrated circuits was developed for the F-14.[3]

In the 1980s, the Standard Central Air Data Computer (SCADC) was developed to retrofit U.S. Air Force and U.S. Navy aircraft.[4][5]

F-14 CADC

The MP944 chip set was the core of the CADC used to control the swing wings and flight controls of the F-14 Tomcat naval interceptor.

The CADC was a multi-chip integrated flight control system developed by Garrett AiResearch and used in early versions of the US Navy's F-14 Tomcat fighter. It is notable for early use of MOS custom integrated circuits and has been claimed as the first microprocessor.[3] The first microprocessor existing on a single chip was the contemporary Intel 4004.

The CADC was designed and built by a team led by Steve Geller and Ray Holt, and supported by the startup American Microsystems. Design work started in 1968 and was completed in June 1970, beating out a number of electromechanical systems that had also been designed for the F-14. It was classified by the Navy[6] until 1998. Ray Holt's story of this design and development is presented in his autobiography The Accidental Engineer.[3]

The CADC consisted of an A-to-D converter, several quartz pressure sensors, and a number of MOS-based microchips. Inputs to the system included the primary flight controls, a number of switches, static and dynamic air pressure (for calculating stall points and aircraft speed) and a temperature gauge. The outputs controlled the primary flight controls, wing sweep, the F-14's leading edge "glove", and the flaps.

The MP944 ran at 375 kHz. It contained six chips used to build the CADC's microprocessor, all based on a 20-bit fixed-point-fraction two's complement number system. They were the parallel multiplier unit (PMU) in a 28-pin DIP, the parallel divider unit (PDU) (28-pin DIP), the random-access storage (RAS) (14-pin DIP), the read-only memory (ROM) (14-pin DIP), the special logic function (SLF) (28-pin DIP), and the steering logic unit (SLU) (28-pin DIP). The complete microprocessor system of 28 circuits consists of 1 PMU, 1 PDU, 1 SLF, 3 RASs, 3 SLUs, and 19 ROMs, enabled by 74,442 transistors.[7]

In 1971, Holt wrote an article about the system for Computer Design magazine,[8] but the Navy classified it, and finally released it in 1998. For this reason, the CADC and MP944 remain fairly obscure in spite of their historical importance.

References

  1. Dictionary of Military and Associated Terms. DIANE Publishing. Oct 1, 1987. p. 63. ISBN 9780941375108.
  2. F-111 Aardvark Pilot's Flight Operating Manual. United States Air Force. August 2007. p. 1–57. ISBN 9781430312123.
  3. Raymond Holt and Leo Sorge (2017). The Accidental Engineer. Lulu.com. p. 36. ISBN 9781387313488. Archived from the original on 26 December 2020. Retrieved 2 June 2020.CS1 maint: uses authors parameter (link)
  4. "New Avionics Standardization Initiative - Standard Central Air Data Computer (SCADC)". Feedback. Wright-Patterson Air Force Base. II (1): 3.
  5. Standard Central Air Data Computer (PDF). GEC Avionics. 1985.
  6. Sudhir Dixit and Ramjee Prasad (2017). Human Bond Communication: The Holy Grail of Holistic Communication and Immersive Experience. 9781119341338. p. 211. Archived from the original on 26 December 2020. Retrieved 2 June 2020.CS1 maint: uses authors parameter (link)
  7. "Ray Holt and the history of MP944/Cadc @ Rome Technopole, 2017 - YouTube". www.youtube.com. Archived from the original on 2020-12-26. Retrieved 2020-11-06.
  8. 1971 paper on the CADC (which was classified and never published)

Further reading

This article is issued from Wikipedia. The text is licensed under Creative Commons - Attribution - Sharealike. Additional terms may apply for the media files.