Fürst-Plattner Rule

The Fürst-Plattner rule (also known as the trans-diaxial effect) describes the stereoselective addition of nucleophiles to cyclohexene derivatives.[1]

Introduction

Cyclohexene derivatives, such as imines, epoxides, and halonium ions, react with nucleophiles in a stereoselective fashion, affording trans-diaxial addition products. The term “Trans-diaxial addition” describes the mechanism of the addition, however the products are likely to equilibrate by ring flip to the lower energy conformer, placing the new substituents in the equatorial position.

Mechanism and Stereochemistry

Epoxidation of a substituted cyclohexene affords a product where the R group resides in the pseudo-equatorial position. Nucleophilic opening of this epoxide can occur by attack at either the 1 or 2 position. The major product forms from attack at the 1 position, due to the instability of the twist boat product formed by addition at the 2 position (disfavored by approximately 5 kcal/mol).[2] Similarly, the Fürst-Plattner rule applies to nucleophilic additions to imines and halonium ions.


Examples

Epoxide addition

A recent example of the Fürst-Plattner rule can be seen from Chrisman et al. where limonene is epoxidized to give a 1:1 mixture of diastereomers. Exposure to a nitrogen nucleophile in water at reflux provides only one ring opened product in 75-85% ee.[3]


Mechanism

The half-chair conformation indicates that attack occurs stereoselectively on the diastereomer where the electrophilic carbon can receive the nucleophile and proceed to the favored chair conformation.


Woodward's Reserpine Synthesis

Although not well understood at the time, the Fürst-Plattner rule played a critical role during R. B. Woodward's synthesis of Reserpine.[4] The problematic stereocenter is highlighted in red, below.



Woodward's synthetic strategy used a Bischler-Napieralski reaction to form the tetrahydrocarbazole portion of Reserpine. The subsequent imine intermediate was treated with sodium borohydride, affording the wrong stereoisomer due to the Fürst-Plattner effect.



Examining the intermediate structure shows that the hydride preferentially added to the 3-carbon via the top face of the imine to avoid an unfavorable twist-boat intermediate. Unfortunately, this outcome required Woodward to perform several additional steps to complete the total synthesis of reserpine with the proper stereochemistry.


References

  1. Fürst, A.; Plattner, P. A. Helv. Chim. Acta 1949, 32, 275. (doi:10.1002/hlca.19490320139)
  2. Kirby, A. J. Stereoelectronic Effects, New York: Oxford Science Publications, 2002. p. 54
  3. Chrisman, W.; Camara, J. N; Marcellini, K.; Singaram, B.; Goralski, C. T.; Hasha, D. L.; Rudolf, P. R.; Nicholson, L.W.; Borodychuck, K. K. Tetrahedron Lett. 2001, 42, 5805-5807.(doi:10.1016/S0040-4039(01)01135-2)
  4. R. B. Woodward, F. E. Bader, H. Bickel, A. J. Frey, R. W. Kierstead, J. Am. Chem. Soc. 1956, 78 (9), pp 2023-2025


This article is issued from Wikipedia. The text is licensed under Creative Commons - Attribution - Sharealike. Additional terms may apply for the media files.