Frame synchronization

In telecommunication, frame synchronization or framing is the process by which, while receiving a stream of framed data, incoming frame alignment signals (i.e., a distinctive bit sequences or syncwords) are identified (that is, distinguished from data bits), permitting the data bits within the frame to be extracted for decoding or retransmission.

Framing

If the transmission is temporarily interrupted, or a bit slip event occurs, the receiver must re-synchronize.

Frame synchronized PCM stream — telemetry application

The transmitter and the receiver must agree ahead of time on which frame synchronization scheme they will use.

Common frame synchronization schemes are:

Framing bit
A common practice in telecommunications, for example in T-carrier, is to insert, in a dedicated time slot within the frame, a noninformation bit or framing bit that is used for synchronization of the incoming data with the receiver. In a bit stream, framing bits indicate the beginning or end of a frame. They occur at specified positions in the frame, do not carry information, and are usually repetitive.
Syncword framing
Some systems use a special syncword at the beginning of every frame.
CRC-based framing
Some telecommunications hardware uses CRC-based framing.

Frame synchronizer

PCM stream prior to frame synchronization

In telemetry applications, a frame synchronizer is used to frame-align a serial pulse code-modulated (PCM) binary stream.

Different types of commutation within a frame synchronized PCM stream

The frame synchronizer immediately follows the bit synchronizer in most telemetry applications. Without frame synchronization, decommutation is impossible.

Frame-synchronized PCM stream

The frame synchronization pattern is a known binary pattern which repeats at a regular interval within the PCM stream. The frame synchronizer recognizes this pattern and aligns the data into minor frames or sub-frames. Typically the frame sync pattern is followed by a counter (sub-frame ID) which dictates which minor or sub-frame in the series is being transmitted. This becomes increasingly important in the decommutation stage where all data is deciphered as to what attribute was sampled. Different commutations require a constant awareness of which section of the major frame is being decoded.

See also

References

     This article incorporates public domain material from the General Services Administration document: "Federal Standard 1037C". (in support of MIL-STD-188)

    Scientific articles

    This article is issued from Wikipedia. The text is licensed under Creative Commons - Attribution - Sharealike. Additional terms may apply for the media files.