Jumping position

The jumping seat is not meant to be held by the rider, but rather it is a fluid seat that changes as the horse's balance changes. It keeps the rider in a position over the horse's center of gravity.

It is important to note that the horse, not the rider, is responsible for opening and closing the rider's angles (notably, the hip and knee). As the horse takes off, it raises its upper body off the ground and comes closer to the rider. This makes the rider's hip angle (between the thigh and chest) close. Over the fence, the rider keeps the angles closed. As the horse lands, it moves away from the rider's body, which allows the hip angle to open and the rider to become more perpendicular to the ground. Also, if the horse takes a jump wrong in some manner, due to rider error or other, the rider may be thrown around a little bit and may sometimes get 'left behind', where the rider's center of balance is behind that of the horse's. This can also throw the horse off balance and lead to other problems such as knocking down a rail.

Poor leg position often makes it difficult for the rider to stay with the horse's efforts

The lower leg is the anchor of the rider's position, and contributes a great deal to his security. Poor lower leg position makes a rider more likely to lose balance over fences, and therefore increases the chance that he may fall. It also tends to decrease the ability of the rider to communicate clearly with his or her horse.

The leg should hang down the horse's side, making even contact along its whole length (inner thigh, knee, and calf), and should not change position when the upper body moves. The rider's weight is dropped along the back of the leg and into the heel through a flexible ankle, so that the heel is lower than the toes. The toes are generally turned out slightly, to a degree greater than in the flatwork-only English riding disciplines such as dressage or saddle seat. This places the back of the calf against the horse, instead of the whole inner calf as in dressage, which decreases the refinement in communication between horse and rider, but anchors the rider and increases security. Toes should turn no more than 45 degrees out.

The stirrups are shortened from the length used for flatwork, adjusted according to the height of the fence. Grand Prix jumpers and eventers on cross-country generally need to shorten the stirrups the most, to allow them to gallop and jump in motion with their horse. The short stirrup provides more leverage and flexibility, and therefore security, better balance and a more secure position should the horse stumble, get a poor distance, or peck on landing. More importantly, a shorter stirrup allows the rider to get off the horse's back between and over the fence, freeing up the back and allowing the horse to bascule. The stirrup leather should remain perpendicular to the ground. The stirrup iron is usually placed on the ball of the foot, allowing the rider to have a flexible, shock-absorbing ankle. The rider should keep even pressure across the foot, rather than pushing on the inside or outside of the stirrup iron, as this makes the lower leg stiff.

The result of a shorter stirrup is that the ankle and knee angle decrease. Both the angles are used as shock-absorbers, opening and closing accordingly with the thrust of takeoff and landing. Stiffness in these angles makes it harder to stay with horse's balance, which may result in the riders "jumping ahead" or being "left behind."

Variations in leg position

Steeplechase jockeys shove their legs forward for extra security.

Leg position may vary slightly between disciplines. Combining a relatively short stirrup with a need for security, Eventers and steeplechase jockies tend to have a slightly forward leg position, with the foot "home" in the iron. The more forward leg position increases security, making it more difficult for the rider to become dislodged. This is important in both sports because riders jump solid fences at high speed, where the horse is more likely to stumble or fall if it hits the fence. Especially in the case of steeplechase jockey, a fall could be extremely dangerous, as the other horses in the race could trample him or her.

The foot can be placed "home" (with the stirrup behind the ball of the foot, near the heel) for security purposes. This decreases the chance that the rider will lose a stirrup should a horse jump or land awkwardly. However, this is very dangerous in the manner that should the rider fall, the foot may become caught in the iron and a rider could be dragged by the horse, ending in serious injury or death.

The rider keeps his or her weight toward the pelvis, and generally has enough weight in the stirrups to be suspended in the air over the saddle, rather than sitting on the horse's back. The rider should not bring the hips too far forward, over the pommel, as seen in the fault of jumping ahead. This changes the rider's balance, and creates a potentially dangerous position.

The hip joints are especially important, as they are the connection between the lower leg (which remains still), and the upper body. The hips should be very flexible, opening and closing as needed. The hips should always move backward from the neutral position, not forward (a sign that the rider is jumping ahead).

Between fences, the rider may ride in two-point position, where the thighs take up weight of rider, not the seatbones. Another position used in galloping, when additional control is needed, is the "half seat," which resembles two-point position, but the rider's seat bones lightly touch the saddle. At slower speeds, or if considerable control is needed, the rider may sit down on the horse, where the seat bones touch the saddle. (Depending on regional terminology, both the half seat and a full seat are sometimes referred to as "three point" position)

Looking down causes the upper body to fall forward.

In all disciplines, the rider should be looking up and in the direction of where he or she needs to go on landing. Looking down tends to cause riders to lean forward with the shoulders and round their back, thus placing them in a precarious position. The head should also not be tilted to one side, as this changes the rider's lateral balance and places more weight on one side.

In general, the back should be flat. Overarching causes stiffness, rounding not only looks bad, but affects the rider's balance. A slightly rounded back is acceptable cross-country when used in the safety seat.

The rider should have an open chest with shoulders back. This helps to prevent the rider from collapsing forward and helps to center the weight of the upper body over the lower leg, therefore helping to keep the rider secure.

Short crest release.

A long crest release being used for a large oxer to allow the horse more freedom.

The automatic release: the rider has a straight line from elbow to bit, and maintains a soft, elastic contact with the horse's mouth.

Slipping the reins while going down a drop.

In all cases, the rider should release the horse over a fence, or in other words, lengthen enough rein so the horse can stretch its neck forward and use it as a balancing mechanism. The key to a good release is relaxed arms with proper hand, wrist, and elbow position. First, the arms (elbows and shoulders) should be soft and elastic, allowing the horse to pull them forward as needed. Preferably, there should be a straight line from bit to elbow (automatic release), as this improves contact and communication between horse and rider. The wrists of the rider should remain soft and straight, as bent wrists tend to stiffen the lower arm. The elbows should be next to the rider's side, not "chicken-winged" and pointing outward, which decreases flexibility and softness.

As in all riding, the hands should be softly closed, neither tightly holding the reins which causes tension and stiffness, or so soft that the reins easily slip through. The one exception to this rule is when the rider needs to slip the reins.

Grand Prix fences will sometimes make even the best riders lose the classic position.

• Swinging lower leg: this usually occurs if the rider pinches or grips with the knees, lacks contact throughout the whole leg (for example, has no contact with the thigh), or rides with stirrups that are too long to provide correct balance and support. Since the lower leg is the rider's anchor, a swinging lower leg greatly decreases security and can be very dangerous if the rider is jumping complex fences at high speeds. There are two common occasions for the swinging leg. First, the Grand Prix rider may lose position because the fences are so large, and the horse's thrust and motion is very difficult to follow. Riders of this caliber are generally able to compensate for their deviations from the classical position due to skill and experience. Second, this is commonly seen by show hunter riders, because their horses have such power jumps and round bascule that it is hard to stay with the jump. In both cases, however, there are riders able to maintain a classical position.
• Toes down/Heels up: This is usually accompanied by the swinging lower leg. Often due to incorrect leg position, too-long stirrup or, in some cases, due to the rider standing on the toe, instead of sinking his or her weight down his lower leg. Again, this places the rider in a very precarious position. Doing this can have the rider too ahead of the horse.

A rider jumping ahead. Note the open hip and knee angles, and the fact that her hips are in front of the line made by the stirrup leather.

• Lower leg shoved forward: Pushing the lower leg slightly forward is appropriate for some fences (such as cross-country) for added security. However, it is not appropriate for riding on level ground in a manicured arena at low speeds. Shoving the lower leg forward tends to decrease the rider's ability to stay with the motion, placing them in "the back seat" and risking that they will fall down on their horse's back while over a fence. It is sometimes associated with "getting left behind."
• Jumping ahead: One of the most common jumping faults. This involves the rider opening the hip angle over the fence, rather than folding back, so that the majority of the body is in front of the line made by the stirrup leather. The lower leg usually swings backward. It places the rider in a very insecure position, since the rider not only loses his or her base of support (the lower leg), but also is in front of the horse's center of motion. This means that the rider will fall forward (and possibly off) if the horse for any reason slows down its motion (stops, runs out, or stumbles). Secondly, this throws the rider's weight over the horse's shoulders, making it very difficult for the horse to take off and harder to get out of trouble on landing. Riders most commonly jump ahead if they are trying to jump for their horse or if they anticipate the take-off and do not wait for the horse to close their hip and knee angles. It is also seen in the hunter arena, as some riders believe it makes their horse's jump look more powerful.

This rider has been left behind, due to his horse's huge jump out of the water. He must be sure to slip his reins to prevent catching the horse in the mouth.

• Getting "left behind": When the rider's body is mostly behind the line made by the perpendicular stirrup leather, and behind the horse's motion. This results in the rider placing extra amount of weight on the horse's back. Hitting the horse in the back is a huge fault in the hunter arenas, because it punishes the horse for rounding into the bascule which is essential in those disciplines, and can cause knockdowns in show jumping. However, being behind the motion is not marked down in eventing when riding cross-country. This is because a solid seat slightly behind the motion places the rider in an extremely secure seat (as riders usually fall off over the shoulder of the horse, not the hindquarters), and because a great bascule is not encouraged cross-country. Instead, it is better if the horse jumps slightly flat for most fences, because they are very wide, and because a flat jump is usually a quicker jump, therefore making it easier for the rider to make the time. This position is performed in degrees depending on the type of fence, with most fences where the rider is behind the motion but not putting his seatbones on the horse's back, and others, such as drop fences, where it is essential that the rider keep his or her seat completely in the saddle for security purposes. However, getting left behind sometimes occurs if the rider's upper body is too open and is leaning back before the fence, if the horse takes off from a very long distance (jumps from too far back), or if the rider's lower leg is shoved so far forward in front of the knee that it forces the upper body back. In all cases, the rider must slip the reins to provide the horse freedom of movement to get over the fence.
• Snapping up: When the rider throws the upper body upward, quickly opening the hip angle on the landing side. This risks that the rider will catch the horse in the mouth or put too much weight on its back. It also disrupts the horse's jump. It usually occurs when a rider has gotten into the habit of falling forward (usually because the lower leg swings back), and tries to compensate by bringing his or her upper body back too soon before the horse has completed the jump.
• Ducking: When the rider bends the hip angles too much and snaps the upper body over one shoulder. This makes the horse carry uneven weight on one side, which makes it more difficult for it to jump. This occurs when the rider has too much weight in one stirrup instead of being evenly centered.

This rider has hit his horse in the mouth because he is not releasing sufficiently.

• Not releasing: This is a cardinal sin in all riding circles, as it causes the horse to jump flat and, more importantly, can result in the horse detesting jumping because it is associated with pain, which will eventually lead to stopping. A poor release may occur for several reasons. First, the rider may use the reins for support over the fence because he or she has not developed correct balance. This rider should be sure to grab mane to avoid hitting the horse in the mouth. Secondly, a rider may be left behind the motion for various reasons. In these cases, the rider should be sure to slip the reins. Some riders ride this way when they are mounted on strong horses, and they wish to tell the horse to slow down over the fence before landing, or get in the habit of overusing their hands between fences and forget to release. In this case, the rider must make a conscious effort to remember to release the horse in the air. It also occurs when riders plant their hands on the neck over a fence to support their upper body, but the hands are placed too far back to allow adequate rein for the horse, or if the riders keep contact during takeoff but stiffen their elbows so that they don't follow that contact forward over the fence. Occasionally, it appears as if a rider is not releasing enough, when in fact he or she is slipping the reins or performing a correct automatic release.
• Incorrect release: When the rider releases by throwing his hands above the horse's neck, into the air, or way down below the neck. This not only looks sloppy, but changes the rider's balance over fences.