Kill switch

An emergency switch in Japan

On railways, an emergency stop is a full application of the brakes in order to bring a train to a stop as quickly as possible. This occurs either by a manual emergency stop activation, such as a button being pushed on the train to start the emergency stop, or on some trains automatically, when the train has passed a red signal or the driver has failed to respond to warnings to check that he/she is still alert, which is known as a dead man's switch. A similar mechanism is the watchdog timer.

In large ships, an emergency stop button pulls the countershaft for the fuel pumps to the stop position, cutting off the fuel supply and stopping the engines. With a controllable-pitch propeller, the stop button may declutch the engine from the propeller.

NASCAR requires all their stock cars to be equipped with a steering wheel-mounted kill switch, in case the accelerator pedal sticks and the driver needs to shut down the engine.

Kill switches are also used on land vehicles as an anti-theft system and as an emergency power off. Such devices are often placed in bait cars and configured so that observing police can trigger the switch remotely.

A related concept is the dead man's switch, where the operator must be holding a button or lever any time the vehicle is operating. A common example of this is the kill switches used by boaters and jetskiers wherein a cord connects the kill switch to the operator (usually by the operator's life jacket or clothing), and if the operator is thrown overboard in an accident, the cord will pull the switch and immediately shut down the vessel's engine. This prevents it from becoming a runaway vessel that could impose a danger to other vessels or swimmers at sea, and allows the operator to swim back to the vessel and re-board it without the risk of being injured by the boat's propeller. A similar device is featured on most lawnmowers: a lever on the handle either disables the ignition system and applies a brake to the flywheel (on a gasoline lawnmower), or cuts the power to the motor (on an electric lawnmower), as long as it is not held down.

Monster Truck Racing Association requires all of their monster trucks to be equipped with kill switches (either remote or in cab), in case the monster truck loses control and the driver needs to shut off the engine. Monster trucks' kill switches are tested before races.

The arrows indicate that the stop button must be turned to reset the switch before the equipment can be restarted.

On large industrial machines, an emergency stop button is typically located on the panel, and possibly in several other areas of the machine. Often, an emergency stop is made wireless using a remote control. This provides a rapid means to disconnect the energy source of the device to protect workers.[1] For fail-safe operation, the emergency stop button is a normally closed switch, which ensures that a broken wire will not prevent it from being activated, but may accidentally activate the emergency stop.

In the European Union, most types of machinery are required to be equipped with an emergency stop according to the Directive 2006/42/EC. Exceptions apply for machinery in which an emergency stop would not lessen the risk as well as for portable hand-held/hand-guided machinery.

The kill switch is also used on such things as band saws and static belt sanders, pillar drills and lathes.

A kill switch is also used for gasoline pumps or any other device that pumps large amounts of explosive or flammable chemicals. There is commonly a single kill switch for all pumps at a pumping station.

Elevators often have a red two-way button on the control panel which is either marked "Emergency Stop" or "Run/Stop". Normally, the button is in the "up" or unpushed position, allowing the elevator to "run" in normal service. When the button is pushed, the elevator comes to an immediate stop. When the button is pulled back out, it resumes normal service, thus the reason for the use of the phrase "Run/Stop". Escalators will typically have a key-operated control that will turn the escalator off, or change its direction to up or down. Next to the key switch will be a red "Emergency Stop" button, which is used in the event of equipment failure, or where there is a potential for injury, such as when someone's shoe gets stuck in the "comb" at the top or bottom of the escalator and there is a risk of serious injury. The key switch is used to return the escalator to service after it has been stopped.

Treadmills often use a safety key with one end magnetically attached to the machine and the other end clipped to the user's waist. If the safety key is pulled out, such as in the event of a fall, the treadmill stops immediately. In other cases, some other treadmills have a more traditional kill switch, often mounted towards the rear of one of the hand railings.

The emergency stop on an amusement ride is similar to that on industrial equipment. Typically brakes on a ride are designed to be disengaged when power is applied; disconnecting power will cause all brakes to engage. Most amusement rides have a computer that can, similar to the rail example provided above, engage the emergency stop when such a ride is determined to be out of operating specification.

By analogy to physical kill switches, "kill switch" can be used to refer to a mechanism incorporated in software. By such its manufacturer or licensor may be able to invoke it, for example if the product is withdrawn, or a maintenance fee has not been paid, or a device has been lost or stolen.[2][3] It can also refer to kill switches for the stopping of malware such as in the WannaCry ransomware attack.[4][5]

There also is a debate about implementing kill switches in robots[6] and advanced artificial intelligence systems.[7]

Wikipedia bots have kill switches due to the possibility of them causing massive vandalism.

In smartphones, a kill switch is a security feature that allows the phone's owner to remotely render the smartphone inoperable if it is lost or stolen. From 2015 this feature is legally required in California for smartphones.[8]

There are also hardware kill switches on some phones, like PinePhone, where the user can by moving a hardware switch inside the phone, disable some hardware, like camera, microphone, Wifi or LTE.[9]

French and Israeli electronic warfare units use kill switches to disable opponents' military systems.[10][11]

• Hardware Trojan – malware embedded in hardware; harder to detect and fix than software vulnerabilities
• Internet kill switch – Single shut off mechanism for all Internet traffic
• Security switch – Hardware device to protect computers, laptops, smartphones and similar devices from unauthorized access or operation
• Blue light station – Combined emergency telephone and emergency power-off switch in rapid transit stations and other points along electrified railways
• USBKill – Anti-forensic software designed to react to unfamiliar USB devices
• SawStop – American table saw manufacturer a fast kill switch for table saws triggered by electrical conductivity of user's finger.
• Battleshort – Emergency override of safety features to complete a mission the opposite of a kill switch, where a system is designed to operate even if damage or injury will occur.