Traditional climbing

The term gear in climbing generally refers to equipment used during climbs (except harness, shoes, chalk bags, and chalk). Gear or protection are mechanical devices that provide safety, either by allowing greater stability in making a move (as in the case of aid climbing) or by dampening force and reducing the distance of a fall. The suitability of individual types of gear depends on the surface and formation of the rock face. The phrase placing gear denotes the act of setting a piece of gear into the rock face and then attaching the rope (via carabiner) before ascending higher. In the event of a fall, the gear acts as a catch-point for the rope, thus preventing the climber from hitting the ground. Gear is placed at frequent intervals to avoid becoming too "run out", and provide protection in the case of a fall.

Nuts started being developed in the 1950s in the United Kingdom, with the original pieces being made from discarded machine nuts with slings threaded through them. Urban legend suggests the first nuts were ones taken from the Snowdon Mountain Railway.[5] These gradually developed into purpose-built nuts.

Prior to about 1970 in the United States, climbing relied mainly on pitons; other types of gear such as nuts, Hexcentrics, Tricams and spring-loaded cams were largely unknown or did not yet exist. As other variants of climbing were not nominally in existence as well, all climbing was in effect trad climbing until the early 1980s when sport climbing emerged in Europe.

Since the 1970s, developments in protective gear have made climbing much safer and more dynamic. For example, nuts—removable pieces of metal which could be jammed into cracks to support weight during a fall but could be removed at the end of a climb—helped fuel trad climbing's growth in popularity and safety. Contemporary protective gear used in trad climbing consists of removable protective devices such as aluminium, steel or brass nuts, hexagonal-shaped chocks, slings, spring-loaded camming devices, and Tricams.

If a climber is soloing they remove placed gear while rappelling back down the climb;[6] if climbing with a partner the second climber will clean the gear during his or her ascent up the pitch.

In protecting the lead climber in both trad and sport, carabiners and slings are used to connect the gear to the climber's lead rope, so that in the event of a fall, the rope can be used (by the belayer below) to catch the falling climber. Modern traditional climbs occasionally have fixed gear (pitons or bolts) in places where there are no opportunities to place adequate removable gear. It is considered bad style to install new protection bolts or pitons on existing climbs that can be completed without them.[7]

Many of the existing pitons, pegs and bolts from the first ascents of routes done many years ago are now considered to be in bad condition, having suffered from weathering. This is especially present on sea cliffs where the salt nature of the air has sped up the oxidisation to create rust and weaken the protection.[8]

A number of knots are required for traditional climbing, to create anchors, to tie in the climbers and to be used during the climb.

• Figure-eight loop is commonly used to tie in the climbers at both ends
• Clove hitch is used when building an anchor using the rope and sometimes to make a climber safe quickly at a belay ledge
• Alpine butterfly can be used to tie a climber into the middle of a rope
• Munter hitch is commonly used to belay without a belay device
• Slip knot or running knot can be used during a climb to sling a protrusion of rock known as a chickenhead, or any trees that may be on the route
• Lark's foot or girth hitch is used to attach slings to trees or spikes and also to a climber's harness
• Double figure-eight loop is used for building a master point off of the climbing rope
• Water knot is used for connecting two pieces of webbing together
• Double bowline is used for tying in or anchoring around a fixed object

A climbing anchor; in this example, all three pieces are placed in the same crack. Generally anchor pieces should be placed in different features, where possible, to protect against rock failure.

When a climber has reached the top of a climb an anchor must be set up to allow the leader to bring up the seconder safely. An anchor has a number of different components which should be put together in a redundant way to make the anchors safe.

• Protection: an anchor typically consists of three to four pieces of protection with the minimum being two pieces. The anchor placements are chosen such that a failure of any single piece will not lead to loss of integrity of the entire system.
• Cordelletes/Web-o-lettes/slings/rope: these are used to tie the pieces of protection of the anchor together with equalised tension using the above-mentioned knots.
• Carabiners: are used to connect the pieces of protection to the rope and also to attach the belay device and lead climber to the anchor.
  • locking carabiners have a twistable ring that will close over the gate to prevent accidental opening
  • non-locking carabiners do not have this safety ring, and are therefore more likely to be accidentally opened by rope or systems. When using non-locking carabiners in place of locking carabiners, they are placed with the gates opposite and opposed, so that it is significantly unlikely that both will be opened simultaneously.

• Leader places gear on harness
• Leader ties into the rope using a figure-eight knot.
• Second climber ties into the other end of the rope.
• Second puts the leader on belay using a belay device or Munter hitch.
• Leader climbs up and places the first piece of protection. The first piece of protection should be multi-directional. This means that it should not be able to be pulled out if it moves up or down.
• Leader uses a quick draw or extended draw to connect the first piece to the rope.
• Leader climbs upwards and places the second piece of protection and repeats until the top of the climb.
• Leader creates an anchor and attaches themself at two points to become safe.
• Seconder takes leader off belay.
• Leader pulls up all the rope until there is no slack between the leader and seconder
• Leader puts second on belay. Leader says "On me" for safety and verification.
• Seconder says "On you" to signify the seconder is on belay.
• Second climbs up and removes the protection the leader has placed on the way up.

A number of types of rock are climbed, each with a varying degree of suitability for traditional climbing. Some examples of rock types used in climbing are granite, sandstone, basalt, gneiss, quartzite and limestone.[10][11] Granite (and other granitic rock) is popular for traditional climbing, being found in such climbing areas as the Yosemite Valley and Joshua Tree National Park.[12][13]

While it may arguably be more dangerous than sport climbing, traditional climbing leaves little or no trace of climbing, which preserves the natural environment of the cliff face (though many significant first ascents in the U.S. were done with a combination of permanent anchors or bolts and crack-fitting hardware were termed "traditional" when the term was first coined—see climbing styles). Sport climbing, on the other hand, requires bolts to be permanently drilled into the rock face providing the exclusive or primary means of protection. The difference between sport and traditional or "trad" styles has caused some periodic contention in the rock climbing community as the respective camps debate the merits of the differing styles.

• Tribe (ungraded, but possibly 5.14d or harder) in Cardarese, Italy, by Jacopo Larcher in 2019.[14]
• Echo Wall (ungraded, but probably harder than Rhapsody[15]) on Ben Nevis, Scotland, first ascent by Dave MacLeod in 2008.[16]
• Rhapsody (E11 7a, 5.14c R/X) in Dumbarton Rock, UK, first ascent by Dave MacLeod in 2006.[17]
• Magic Line (5.14c, 8c+) in Yosemite, pinkpointed by Ron Kauk in 1996, redpointed by Lonnie Kauk in 2018, first redpoint repeat and first female ascent by Hazel Findlay in 2019.[18]
• Blackbeard’s Tears (5.14c, 8c+) at Redwood Coast, U.S., first ascent by Ethan Pringle in 2016.[19]
• Meltdown (5.14c, 8c+) in Yosemite, first ascent by Beth Rodden in 2008.[20]
• Pura Pura (5.14c, 8c+) in Valle dell’Orco, Italy, first ascent by Tom Randall in 2014.[21]
• Recovery Drink (5.14c, 8c+) in Jossingford, Norway, first ascent by Nico Favresse in 2013.[22]
• Cobra Crack (5.14b/c, 8c/+) in Squamish, Canada, first ascent by Sonnie Trotter in 2006.[23]
• Century Crack (5.14b) in Canyonlands, Utah, U.S., first ascent by Tom Randall and Pete Whittaker in 2011.[24]

• "Tricksters and Traditionalists" by Tom Higgins
• List of traditional climbing gear