Two-ray ground-reflection model

The two-rays ground-reflection model is a multipath radio propagation model which predicts the path losses between a transmitting antenna and a receiving antenna when they are in line of sight (LOS). Generally, the two antenna each have different height. The received signal having two components, the LOS component and the reflection component formed predominantly by a single ground reflected wave.

2-Ray Ground Reflection diagram including variables for the 2-ray ground reflection propagation algorithm.

Mathematical derivation[1][2]

From the figure the received line of sight component may be written as

and the ground reflected component may be written as

where is the transmitted signal, is the length of the direct line-of-sight (LOS) ray, is the length of the ground-reflected ray, is the combined antenna gain along the LOS path, is the combined antenna gain along the ground-reflected path, is the wavelength of the transmission (, where is the speed of light and is the transmission frequency), is ground reflection coefficient and is the delay spread of the model which equals . The ground reflection coefficient is[1]

where or depending if the signal is horizontal or vertical polarized, respectively. is computed as follows.

The constant is the relative permittivity of the ground (or generally speaking, the material where the signal is being reflected), is the angle between the ground and the reflected ray as shown in the figure above.

From the geometry of the figure, yields:

and

,

Therefore, the path-length difference between them is

and the phase difference between the waves is

The power of the signal received is

where denotes average (over time) value.

Approximation

If the signal is narrow band relative to the inverse delay spread , so that , the power equation may be simplified to

where is the transmitted power.

When distance between the antennas is very large relative to the height of the antenna we may expand ,

using the Taylor series of :

and taking the first two terms only,

The phase difference can then be approximated as

When is large, ,

Reflection co-efficient tends to -1 for large d.

and hence

Expanding using Taylor series

and retaining only the first two terms

it follows that

so that

which is accurate in the far field region, i.e. when (angles are measured here in radians, not degrees) or, equivalently,

and where the combined antenna gain is the product of the transmit and receive antenna gains, . This formula was first obtained by B.A. Vvedenskij.[3]

Note that the power decreases with as the inverse fourth power of the distance in the far field, which is explained by the destructive combination of the direct and reflected paths, which are roughly of the same in magnitude and are 180 degrees different in phase. is called "effective isotropic radiated power" (EIRP), which is the transmit power required to produce the same received power if the transmit antenna were isotropic.

In logarithmic units

In logarithmic units :

Path loss :

Power vs. distance characteristics

Power vs distance plot

When the distance between antennas is less than the transmitting antenna height, two waves are added constructively to yield bigger power. As distance increases, these waves add up constructively and destructively, giving regions of up-fade and down-fade. As the distance increases beyond the critical distance or first Fresnel zone, the power drops proportionally to an inverse of fourth power of . An approximation to critical distance may be obtained by setting Δφ to π as the critical distance to a local maximum.

An extension to large antenna heights

The above approximations are valid provided that , which may be not the case in many scenarios, e.g. when antenna heights are not much smaller compared to the distance, or when the ground cannot be modelled as an ideal plane . In this case, one cannot use and more refined analysis is required, see e.g.[4]

As a case of log distance path loss model

The standard expression of Log distance path loss model is

The path loss of 2-ray ground reflected wave is

where

,

and

for the critical distance.

As a case of multi-slope model

The 2-ray ground reflected model may be thought as a case of multi-slope model with break point at critical distance with slope 20 dB/decade before critical distance and slope of 40 dB/decade after the critical distance. Using the free-space and two-ray model above, the propagation path loss can be expressed as

where and are the free-space and 2-ray path losses.

See also

References

  1. Jakes, W.C. (1974). Microwave Mobile Communications. New York: IEEE Press.
  2. Rappaport, Theodore S. (2002). Wireless Communications: Principles and Practice (2. ed.). Upper Saddle River, NJ: Prentice Hall PTR. ISBN 978-0130422323.
  3. Vvedenskij, B.A. (December 1928). "On Radio Communications via Ultra-Short Waves". Theoretical and Experimental Electrical Engineering (12): 447–451.
  4. Loyka, Sergey; Kouki, Ammar (October 2001). "Using Two Ray Multipath Model for Microwave Link Budget Analysis". IEEE Antennas and Propagation Magazine. 43 (5): 31–36.

Further reading

  • S. Salous, Radio Propagation Measurement and Channel Modelling, Wiley, 2013.
  • J.S. Seybold, Introduction to RF propagation, Wiley, 2005.
  • K. Siwiak, Radiowave Propagation and Antennas for Personal Communications, Artech House, 1998.
  • M.P. Doluhanov, Radiowave Propagation, Moscow: Sviaz, 1972.
  • V.V. Nikolskij, T.I. Nikolskaja, Electrodynamics and Radiowave Propagation, Moscow: Nauka, 1989.
This article is issued from Wikipedia. The text is licensed under Creative Commons - Attribution - Sharealike. Additional terms may apply for the media files.