Yamaha WR450F

Yamaha introduced the WR 400F in 1998. The 400F is a 400 cc (24 cu in) four-stroke off-road motorcycle produced for three years, beginning in 1998 and ending in 2000 (only the YZ was upgraded to 426 cc in 2000). The WR400F is related to the YZ400F, a motocross model. Like the YZ400, it was considered to be a groundbreaking model in motorcycle history, ushering in the four-stroke era which ended the dominance of two-stroke engines in motocross and offroad racing. While many modern performance four-stroke dirt bikes have been criticized for excessive rebuild costs and short motor lifespans, the Yamaha WR400F has an impressive record of reliability, often attributed to its steel valves and generous oil capacity.

In 2001 the WR400F's engine was uprated and it became the WR426F increasing the displacement to 426 cc (26.0 cu in) for greater power and throttle response. A beefier YZ style clutch basket and plates than those on the WR400 improved clutch performance. Frame geometry was identical to the 2002 YZ250 and YZ426F with a 58.7 inch wheelbase and 14.7 inches of ground clearance. This was the last WR to make use of a manual compression release for starting.

For 2003, the engine displacement was increased to 449 cc (27.4 cu in), the fuel tank was reduced to 2.6 gallons [1] and the bike came with an electric starter as standard equipment. The 2005 WR weighed in at 244 pounds dry, the seat height was reduced to 38 inches and the fuel tank was decreased to 2.1 gallons.[1][4] The 2006 WR weighed in at 249 pounds dry[1] and produced 42 horsepower.[5]

A limited production version of the WR450F was the WR450F 2-Trac, which featured 2-wheel drive. The gearbox output sprocket drove a short, fully enclosed chain to a pump, which in turn pushed the oil to the front hub via the pipe and back via the parallel pipe.[6] A maximum of 15% of the power was transmitted to the front wheel at any time.[6] Yamaha planned on building 250 2-Tracs in 2004, but only a few were built, which were used for enduro racing.[6] 2006 was the last year of the steel frames.

The 2003 and 2004 models were red sticker bikes in California.

Fourth Generation WR450F

2010 Yamaha WR450F
Manufacturer	Yamaha Motor Corporation
Production	2007 through 2011
Predecessor	WR450F
Engine	Titanium five-valve, 449 cc, 95mm x 63.4mm stroke, compression ratio 12.3:1
Transmission	5-speed, constant mesh[7]
Frame type	Aluminum, semi-double cradle[7]
Suspension	Front: KYB cartridge forks with 11.8 in (300 mm) travel Rear: KYB shock with 12 in (305 mm) travel[7]
Brakes	Front: 250 mm disc Rear: 245 mm disc
Tires	Front: 80/100-21 51M Rear: 110/100-18 64M
Rake, trail	27.3°, 117 mm (4.6 in) [7]
Wheelbase	1,485 mm (58 in)[7]
Dimensions	L: 2,175 mm (86 in)[7] W: 825 mm (32 in)[7] H: 1,295 mm (51 in)[7]
Seat height	980 mm (39 in)[7]
Weight	248 lb (112 kg)[7] (dry) 273 lb (124 kg) (wet)
Fuel capacity	2.11 US gal (8.0 L)[7]
Related	YZ450F, WR250F

For 2007, the WR gained an aluminum frame dropping the weight from 249 to 246 pounds.[8] In addition to the aluminum frame, the 2007 WR450F saw a revised dry-sump engine, with a new balancer, cylinder head, and camshafts with less lift and duration than previous generations and restyled plastics. 2009 saw new graphics, and 2010 was not sold in the US.

Fifth Generation WR450F

2012 Yamaha WR450F
Manufacturer	Yamaha Motor Corporation
Production	2012 through 2015
Predecessor	WR450F
Engine	Titanium five-valve, 449 cc, 95mm x 63.4mm stroke, compression ratio 12.3:1
Transmission	5-speed, constant-mesh[9]
Frame type	Aluminum, semi-double cradle[9]
Suspension	Front: KYB SSS cartridge forks with 11.8 in (300 mm) travel Rear: KYB shock with 12 in (305 mm) travel
Brakes	Front: 250 mm disc Rear: 245 mm disc[9]
Tires	Front: 80/100-21 51M Rear: 120/90-18 65M[9]
Rake, trail	27.0°, 117 mm (4.6 in) [9]
Wheelbase	1,465 mm (58 in)[9]
Dimensions	L: 2,160 mm (85 in)[9] W: 825 mm (32 in)[9] H: 1,275 mm (50 in)[9]
Seat height	960 mm (38 in)[9]
Weight	273 lb (124 kg)[9] (wet)
Fuel capacity	1.98 US gal (7.5 L)[9]
Oil capacity	1.27 US qt (1.20 L)[9]
Related	YZ450F, WR250F

After 3 years of design, the all-new 2012 WR450F was released and featured a 2012 YZ250F frame, KYB SSS forks, fuel injection, and an altered motor position.[10] Per Yamaha's designers, the only modifications required to the YZ250F chassis were updated motor mounts.[10] The engine was rotated back to move the center of gravity and improve handling[10]

For 2016, the WR was given the reverse slant, 4-valve, fuel injected motor previously available in the YZ450F since 2010. Yamaha also introduced a new model, the YZ450FX, a more Enduro competition oriented version of the off-road 450 utilizing more design elements of the motocross model such as stiffer suspension and a close ratio gear box while maintaining electric start and the 18" rear wheel.

For 2017, the WR450F largely remained the same, except for modifications to the air box cover as well as a change from silver to black rims.

For 2018, the WR450F remained similar to the 2016-2017 models, with a large distinction being that the bike was no longer available to register as green sticker in the state of California.

https://www.yamahamotorsports.com/off-road/models/2016/wr450f

• Yamaha WR250F
• Yamaha YZ450F