Arnhem smock mill (1960)

The mill was originally built to drain the Oosterpolder at Noordlaren, Groningen in 1862, replacing an earlier mill. In 1895, the upper part of the wooden upright shaft was replaced by one of cast iron, made by the IJzergieterij De Prins van Oranje, 's Gravenhage, South Holland. At that time, one pair of Common sails were replaced by Patent sails. Later, the mill ran with four Patent sails. In 1913, a steam-powered pumping station was constructed to assist the drainage of the polder during periods of calm. Electricity replaced steam in 1939. In 1942, it was proposed to demolish the mill, but this was postponed due to World War II. Post-war, the polder board and the Gemeente Haren disagreed over the proposal to demolish the mill. A licence to demolish was issued on 17 January 1951. The mill was dismantled in 1953 and moved to Arnhem.[1]

The mill was rebuilt in 1960, incorporating the base of a demolished windmill from Spijkerboor. The Patent sails were replaced with Common sails, but the mill was not returned to working order. This did not occur until 1995 when the mill was restored. The sails were fitted with the Fok system on their leading edges.[2]

The mill at Noordlaren, August 1942.

The mill is what the Dutch describe as a Grondzeiler. It is a two-storey smock mill on a single-storey base. There is no stage, the sails reaching almost to ground level. The mill is winded by tailpole and winch. The smock and cap are thatched. The sails are Common sails, fitted with the Fok system on their leading edges. They have a span of 19.90 metres (65 ft 3 in). The sails are carried on a cast-iron windshaft which was cast by the IJzergieterij De Prins van Oranje, 's Gravenhage, South Holland in 1960. The windshaft carries the wooden brake wheel which has 48 cogs. This drives the wallower (29 cogs) at the top of the upright shaft. At the bottom of the upright shaft there are two crown wheels. The upper crown wheel, which has 40 cogs drives an Archimedes' screw via a crown wheel. The lower crown wheel, which has 35 cogs is carried on the axle of the Archimedes' screw.[2]

The mill is open during museum opening hours.[2]

Windmills in Arnhem

• De Hoop
• De Kroon

Windmills in the Netherlands Open Air Museum

• Boktjasjker
• Het Fortuyn
• Huizermolen
• Mijn Genoegen
• Spinnenkop
• Arnhem post mill (1946)
• Arnhem post mill (1989)

Wikimedia Commons has media related to Poldermolen, Nederlands Openluchtmuseum.

• Openluchtmuseum webpage about the mill (in Dutch)