Bleed air

Bleed air is compressed air taken from the compressor stage of a gas turbine upstream of its fuel-burning sections. Automatic air supply and cabin pressure controller (ASCPCs) valves bleed air from high or low stage engine compressor sections. Low stage air is used during high power setting operation, and high during descent and other low power setting operations.[1][2] Bleed air from that system can be utilized for internal cooling of the engine, cross-starting another engine, engine and airframe anti-icing, cabin pressurization, pneumatic actuators, air-driven motors, pressurizing the hydraulic reservoir, and waste and water storage tanks. Some engine maintenance manuals refer to such systems as "customer bleed air".[3][4][5] Bleed air is valuable in an aircraft for two properties: high temperature and high pressure (typical values are 200–250 °C and 275 kPa (40 PSI), for regulated bleed air exiting the engine pylon for use throughout the aircraft).

Uses
Cabin pressure and bleed air controls in a Boeing 737-800

In civil aircraft, bleed air's primary use is to provide pressure for the aircraft cabin by supplying air to the environmental control system. Additionally, bleed air is used to keep critical parts of the plane (such as the wing leading edges) ice-free.[6]

Bleed air is used on many aircraft systems because it is easily available, reliable, and a potent source of power. For example, bleed air from an airplane engine is used to start the remaining engines. Lavatory water storage tanks are pressurized by bleed air that is fed through a pressure regulator.[6]

When used for cabin pressurization, the bleed air from the engine must first be cooled (as it exits the compressor stage at temperatures as high as 250 °C) by passing it through an air-to-air heat exchanger cooled by cold outside air. It is then fed to an air cycle machine unit that regulates the temperature and flow of air into the cabin, keeping the environment comfortable.[6]

Bleed air is also used to heat the engine intakes. This prevents ice from forming, accumulating, breaking loose, and being ingested by the engine, possibly damaging it.[7]

On aircraft powered by jet engines, a similar system is used for wing anti-icing by the 'hot-wing' method. In icing conditions, water droplets condensing on a wing's leading edge can freeze. If that happens, the ice build-up adds weight and changes the shape of the wing, causing a degradation in performance, and possibly a critical loss of control or lift. To prevent this, hot bleed air is pumped through the inside of the wing's leading edge, heating it to a temperature above freezing, which prevents the formation of ice. The air then exits through small holes in the wing edge.

On propeller-driven aircraft, it is common to use bleed air to inflate a rubber boot on the leading edge, breaking the ice loose after it has already formed.[6][7]

Bleed air from the high-pressure compressor of the engine is used to supply reaction control valves as used for part of the flight control system in the Harrier jump jet family of military aircraft.[8]

Contamination
Main article: Fume event

On about 1 in 5,000 flights,[9] bleed air used for air conditioning and pressurization can be contaminated by chemicals such as oil or hydraulic fluid.[10] This is known as a fume event. While those chemicals can be irritating, such events have not been established to cause long-term harm.[11][12]

Certain neurological and respiratory ill health effects have been linked anecdotally to exposure to bleed air that has been alleged to have been contaminated with toxic levels on commercial and military aircraft. This alleged long-term illness is referred to as aerotoxic syndrome, but it is not a medically recognized syndrome. One potential contaminant is tricresyl phosphate.[13]

Many lobbying groups have been set up to advocate for research into this hazard, including the Aviation Organophosphate Information Site (AOPIS) (2001), the Global Cabin Air Quality Executive (2006) and the UK-based Aerotoxic Association (2007). Cabin Environment Research is one of many functions of the ACER Group,[14] but their researchers have not yet established any causal relationship.[15][16]

Although a study made for the EU in 2014 confirmed that contamination of cabin air could be a problem, that study also stated:

"A lot of reported fume events caused comfort limitations for the occupants but posed no danger. A verification of cabin air contamination with toxic substances (e.g. TCP/TOCP) was not possible with the fume events the BFU investigated."[17]

While no scientific evidence to date has found that airliner cabin air has been contaminated to toxic levels (exceeding known safe levels, in ppm, of any dangerous chemical), a court in Australia in March 2010 found in favor of a former airline flight attendant who claimed she suffered chronic respiratory problems after being exposed to oil fumes on a trip in March 1992.[18] Such testing is infrequent due to Boeing's refusal to install air quality sensors in its planes, fearing lawsuits from crew or passengers over fume events, and airlines refused to allow flight attendants to carry air samplers after Congress mandated chemical measurements.[19]

The FAA has revoked the medical certificates of several pilots who developed neurological issues after fume events.[20] A judge who awarded workers' compensation to a pilot who had suffered toxic encephalopathy (brain damage) from a fume event condemned the airline industry's obstructionism around fume events.[19]

In July 2015, pilots on a Spirit Airlines flight were partially incapacitated by fumes in bleed air.[21]

Bleedless aircraft

Bleed air systems have been in use for several decades in passenger jets. Recent improvements in solid-state electronics have enabled pneumatic power systems to be replaced by electric power systems. In a bleedless aircraft such as the Boeing 787, each engine has two variable-frequency electrical generators to compensate for not providing compressed air to external systems. Eliminating bleed air and replacing it with extra electric generation is believed to provide a net improvement in engine efficiency, lower weight, and ease of maintenance.[22]

Benefits

A bleedless aircraft achieves fuel efficiency by eliminating the process of compressing and decompressing air, and by reducing the aircraft's mass due to the removal of ducts, valves, heat exchangers, and other heavy equipment.[23]

The APU (auxiliary power unit) does not need to supply bleed air when the main engines are not operating. Aerodynamics are improved due to the lack of bleed air vent holes on the wings. By driving cabin air supply compressors at the minimum required speed, no energy wasting modulating valves are required. High-temperature, high-pressure air cycle machine (ACM) packs can be replaced with low temperature, low-pressure packs to increase efficiency. At cruise altitude, where most aircraft spend the majority of their time and burn the majority of their fuel, the ACM packs can be bypassed entirely, saving even more energy. Since no bleed air is taken from the engines for the cabin, the potential of engine oil contamination of the cabin air supply is eliminated.[23]

Lastly, advocates of the design say it improves safety as heated air is confined to the engine pod, as opposed to being pumped through pipes and heat exchangers in the wing and near the cabin, where a leak could damage surrounding systems.[23]

See also

References
  1. "777 Bleed Air".
  2. "Global 300 Bleed Air". Archived from the original (PDF) on 2016-03-27. Retrieved 2019-06-11.
  3. "Naval Operations Manual".
  4. "European Space Agency" (PDF).
  5. "mil-spec".
  6. "Bleed Air Systems". Skybrary.aero. Retrieved January 1, 2013.
  7. "Ice Protection Systems". Skybrary. Retrieved January 1, 2013.
  8. "Technical" page on harrier.org.uk website, viewed 2013-11-24
  9. Feldman, Kiera. "'We are slowly being poisoned.' How toxic fumes seep into the air you breathe on planes". Los Angeles Times.
  10. Sarah Nassauer (30 July 2009). "Up in the Air: New Worries About 'Fume Events' on Planes". Wall Street Journal. Retrieved 29 December 2012.
  11. Nassauer, Sarah (July 30, 2009). "Up in the Air: New Worries About 'Fume Events' on Planes". Wall Street Journal. Retrieved December 31, 2012.
  12. "Skydrol FAQ". Skydrol. Retrieved December 31, 2012.
  13. Feldman, Kiera. "'We are slowly being poisoned.' How toxic fumes seep into the air you breathe on planes". Los Angeles Times.
  14. "Airliner Cabin Environment Research". Archived from the original on 2013-07-28. Retrieved 2013-07-16.
  15. Bagshaw, Michael (September 2008). "The Aerotoxic Syndrome" (PDF). European Society of Aerospace Medicine. Archived from the original (PDF) on August 27, 2010. Retrieved December 31, 2012.
  16. Select Committee on Science and Technology (2000). "Chapter 4: Elements Of Healthy Cabin Air". Science and Technology – Fifth Report (Report). House of Lords. Retrieved 2010-07-05.
  17. "Study of Reported Occurrences in Conjunction with Cabin Air Quality in Transport Aircraft" (PDF). German Federal Bureau of Aircraft Accident Investigation. 2014.
  18. Turner v Eastwest Airlines Limited (2009) at Dust Diseases Tribunal of New South Wales
  19. Feldman, Kiera. "'We are slowly being poisoned.' How toxic fumes seep into the air you breathe on planes". Los Angeles Times.
  20. Feldman, Kiera. "'We are slowly being poisoned.' How toxic fumes seep into the air you breathe on planes". Los Angeles Times.
  21. Feldman, Kiera. "'We are slowly being poisoned.' How toxic fumes seep into the air you breathe on planes". Los Angeles Times.
  22. AERO 787 No Bleed Systems The Boeing Company 2008
  23. Sinnett, Mike (2008). "787 No-Bleed Systems". Boeing. Retrieved January 1, 2013.
This article is issued from Wikipedia. The text is licensed under Creative Commons - Attribution - Sharealike. Additional terms may apply for the media files.