Avionics

Avionics plays a heavy role in modernization initiatives like the Federal Aviation Administration's (FAA) Next Generation Air Transportation System project in the United States and the Single European Sky ATM Research (SESAR) initiative in Europe. The Joint Planning and Development Office put forth a roadmap for avionics in six areas:[7]

• Published Routes and Procedures – Improved navigation and routing
• Negotiated Trajectories – Adding data communications to create preferred routes dynamically
• Delegated Separation – Enhanced situational awareness in the air and on the ground
• LowVisibility/CeilingApproach/Departure – Allowing operations with weather constraints with less ground infrastructure
• Surface Operations – To increase safety in approach and departure
• ATM Efficiencies – Improving the ATM process

The Aircraft Electronics Association reports $1.73 billion avionics sales for the first three quarters of 2017 in business and general aviation, a 4.1% yearly improvement: 73.5% came from North America, forward-fit represented 42.3% while 57.7% were retrofits as the U.S. deadline of January 1, 2020 for mandatory ADS-B out approach.[8]

Communications connect the flight deck to the ground and the flight deck to the passengers. On‑board communications are provided by public-address systems and aircraft intercoms.

The VHF aviation communication system works on the airband of 118.000 MHz to 136.975 MHz. Each channel is spaced from the adjacent ones by 8.33 kHz in Europe, 25 kHz elsewhere. VHF is also used for line of sight communication such as aircraft-to-aircraft and aircraft-to-ATC. Amplitude modulation (AM) is used, and the conversation is performed in simplex mode. Aircraft communication can also take place using HF (especially for trans-oceanic flights) or satellite communication.

Air navigation is the determination of position and direction on or above the surface of the Earth. Avionics can use satellite navigation systems (such as GPS and WAAS), INS( inertial navigation system), ground-based radio navigation systems (such as VOR or LORAN), or any combination thereof. Some navigation systems such as GPS calculate the position automatically and display it to the flight crew on moving map displays. Older ground-based Navigation systems such as VOR or LORAN requires a pilot or navigator to plot the intersection of signals on a paper map to determine an aircraft's location; modern systems calculate the position automatically and display it to the flight crew on moving map displays.

The Airbus A380 glass cockpit featuring pull-out keyboards and two wide computer screens on the sides for pilots.

The first hints of glass cockpits emerged in the 1970s when flight-worthy cathode ray tube (CRT) screens began to replace electromechanical displays, gauges and instruments. A "glass" cockpit refers to the use of computer monitors instead of gauges and other analog displays. Aircraft were getting progressively more displays, dials and information dashboards that eventually competed for space and pilot attention. In the 1970s, the average aircraft had more than 100 cockpit instruments and controls.[10] Glass cockpits started to come into being with the Gulfstream G‑IV private jet in 1985. One of the key challenges in glass cockpits is to balance how much control is automated and how much the pilot should do manually. Generally they try to automate flight operations while keeping the pilot constantly informed.[10]

Aircraft have means of automatically controlling flight. Autopilot was first invented by Lawrence Sperry during World War I to fly bomber planes steady enough to hit accurate targets from 25,000 feet. When it was first adopted by the U.S. military, a Honeywell engineer sat in the back seat with bolt cutters to disconnect the autopilot in case of emergency. Nowadays most commercial planes are equipped with aircraft flight control systems in order to reduce pilot error and workload at landing or takeoff.[4]

The first simple commercial auto-pilots were used to control heading and altitude and had limited authority on things like thrust and flight control surfaces. In helicopters, auto-stabilization was used in a similar way. The first systems were electromechanical. The advent of fly by wire and electro-actuated flight surfaces (rather than the traditional hydraulic) has increased safety. As with displays and instruments, critical devices that were electro-mechanical had a finite life. With safety critical systems, the software is very strictly tested.

Fuel Quantity Indication System (FQIS) monitors the amount of fuel aboard. Using various sensors, such as capacitance tubes, temperature sensors, densitometers & level sensors, the FQIS computer calculates the mass of fuel remaining on board.

Fuel Control and Monitoring System (FCMS) reports fuel remaining on board in a similar manner, but, by controlling pumps & valves, also manages fuel transfers around various tanks.

• Refuelling control to upload to a certain total mass of fuel and distribute it automatically.
• Transfers during flight to the tanks that feed the engines. E.G. from fuselage to wing tanks
• Centre of gravity control transfers from the tail (Trim) tanks forward to the wings as fuel is expended
• Maintaining fuel in the wing tips (to help stop the wings bending due to lift in flight) & transferring to the main tanks after landing
• Controlling fuel jettison during an emergency to reduce the aircraft weight.

To supplement air traffic control, most large transport aircraft and many smaller ones use a traffic alert and collision avoidance system (TCAS), which can detect the location of nearby aircraft, and provide instructions for avoiding a midair collision. Smaller aircraft may use simpler traffic alerting systems such as TPAS, which are passive (they do not actively interrogate the transponders of other aircraft) and do not provide advisories for conflict resolution.

To help avoid controlled flight into terrain (CFIT), aircraft use systems such as ground-proximity warning systems (GPWS), which use radar altimeters as a key element. One of the major weaknesses of GPWS is the lack of "look-ahead" information, because it only provides altitude above terrain "look-down". In order to overcome this weakness, modern aircraft use a terrain awareness warning system (TAWS).

Commercial aircraft cockpit data recorders, commonly known as "black boxes", store flight information and audio from the cockpit. They are often recovered from an aircraft after a crash to determine control settings and other parameters during the incident.

Weather systems such as weather radar (typically Arinc 708 on commercial aircraft) and lightning detectors are important for aircraft flying at night or in instrument meteorological conditions, where it is not possible for pilots to see the weather ahead. Heavy precipitation (as sensed by radar) or severe turbulence (as sensed by lightning activity) are both indications of strong convective activity and severe turbulence, and weather systems allow pilots to deviate around these areas.

Lightning detectors like the Stormscope or Strikefinder have become inexpensive enough that they are practical for light aircraft. In addition to radar and lightning detection, observations and extended radar pictures (such as NEXRAD) are now available through satellite data connections, allowing pilots to see weather conditions far beyond the range of their own in-flight systems. Modern displays allow weather information to be integrated with moving maps, terrain, and traffic onto a single screen, greatly simplifying navigation.

Modern weather systems also include wind shear and turbulence detection and terrain and traffic warning systems.[11] In‑plane weather avionics are especially popular in Africa, India, and other countries where air-travel is a growing market, but ground support is not as well developed.[12]

There has been a progression towards centralized control of the multiple complex systems fitted to aircraft, including engine monitoring and management. Health and usage monitoring systems (HUMS) are integrated with aircraft management computers to give maintainers early warnings of parts that will need replacement.

The integrated modular avionics concept proposes an integrated architecture with application software portable across an assembly of common hardware modules. It has been used in fourth generation jet fighters and the latest generation of airliners.

While aircraft communications provide the backbone for safe flight, the tactical systems are designed to withstand the rigors of the battle field. UHF, VHF Tactical (30–88 MHz) and SatCom systems combined with ECCM methods, and cryptography secure the communications. Data links such as Link 11, 16, 22 and BOWMAN, JTRS and even TETRA provide the means of transmitting data (such as images, targeting information etc.).

Airborne radar was one of the first tactical sensors. The benefit of altitude providing range has meant a significant focus on airborne radar technologies. Radars include airborne early warning (AEW), anti-submarine warfare (ASW), and even weather radar (Arinc 708) and ground tracking/proximity radar.

The military uses radar in fast jets to help pilots fly at low levels. While the civil market has had weather radar for a while, there are strict rules about using it to navigate the aircraft.

Dipping sonar fitted to a range of military helicopters allows the helicopter to protect shipping assets from submarines or surface threats. Maritime support aircraft can drop active and passive sonar devices (sonobuoys) and these are also used to determine the location of enemy submarines.

Electro-optic systems include devices such as the head-up display (HUD), forward looking infrared (FLIR), infra-red search and track and other passive infrared devices (Passive infrared sensor). These are all used to provide imagery and information to the flight crew. This imagery is used for everything from search and rescue to navigational aids and target acquisition.

Electronic support measures and defensive aids systems are used extensively to gather information about threats or possible threats. They can be used to launch devices (in some cases automatically) to counter direct threats against the aircraft. They are also used to determine the state of a threat and identify it.

The avionics systems in military, commercial and advanced models of civilian aircraft are interconnected using an avionics databus. Common avionics databus protocols, with their primary application, include:

• Aircraft Data Network (ADN): Ethernet derivative for Commercial Aircraft
• Avionics Full-Duplex Switched Ethernet (AFDX): Specific implementation of ARINC 664 (ADN) for Commercial Aircraft
• ARINC 429: Generic Medium-Speed Data Sharing for Private and Commercial Aircraft
• ARINC 664: See ADN above
• ARINC 629: Commercial Aircraft (Boeing 777)
• ARINC 708: Weather Radar for Commercial Aircraft
• ARINC 717: Flight Data Recorder for Commercial Aircraft
• ARINC 825: CAN bus for commercial aircraft (for example Boeing 787 and Airbus A350)
• Commercial Standard Digital Bus
• IEEE 1394b: Military Aircraft
• MIL-STD-1553: Military Aircraft
• MIL-STD-1760: Military Aircraft
• TTP – Time-Triggered Protocol: Boeing 787, Airbus A380, Fly-By-Wire Actuation Platforms from Parker Aerospace
• TTEthernet – Time-Triggered Ethernet: Orion spacecraft