Bowline

The bowline's name has an earlier meaning, dating to the age of sail. On a square-rigged ship, a bowline (sometimes spelled as two words, bow line) is a rope that holds the edge of a square sail towards the bow of the ship and into the wind, preventing it from being taken aback.[5] A ship is said to be on a "taut bowline" when these lines are made as taut as possible in order to sail close-hauled to the wind.[6]

The bowline knot is thought to have been first mentioned in John Smith's 1691 work A Sea Grammar under the name Boling knot. Smith considered the knot to be strong and secure, saying, "The Boling knot is also so firmly made and fastened by the bridles into the cringles of the sails, they will break, or the sail split before it will slip."[7][lower-alpha 1]

Another possible finding was discovered on the rigging of the Ancient Egyptian Pharaoh Khufu's solar ship during an excavation in 1954.[8]

The bowline is used to make a loop at one end of a line. It is tied with the rope's working end also known as the "tail" or "end". The loop may pass around or through an object during the making of the knot. The knot tightens when loaded at (pulled by) the standing part of the line.

The bowline is commonly used in sailing small craft, for example to fasten a halyard to the head of a sail or to tie a jib sheet to a clew of a jib. The bowline is well known as a rescue knot for such purposes as rescuing people who might have fallen down a hole, or off a cliff onto a ledge. This knot is particularly useful in such a situation because it is possible to tie with one hand. As such, a person needing rescue could hold onto the rope with one hand and use the other to tie the knot around their waist before being pulled to safety by rescuers. The Federal Aviation Administration recommends the bowline knot for tying down light aircraft.[9]

A rope with a bowline retains approximately 2/3 of its strength, with variances depending upon the nature of the rope, as in practice the exact strength depends on a variety of factors.

In the United Kingdom, the knot is listed as part of the training objectives for the Qualified Firefighter Assessment.[10]

A mnemonic used to teach the tying of the bowline is to imagine the end of the rope as a rabbit, and where the knot will begin on the standing part, a tree trunk. First a loop is made near the end of the rope, which will act as the rabbit's hole. Then the "rabbit" comes up the hole, goes round the tree right to left, then back down the hole. This can be taught to children with the rhyme: "Up through the rabbit hole, round the big tree; down through the rabbit hole and off goes he." A single handed method can also be used; see this animation.

• 
  The rabbit hole.
• 
  Out comes the rabbit,
• 
  runs around the tree (to the left),
• 
  and hops back into its hole.
• 
  Lightning method, tied on a ring. Pull per the blue arrows.

There is a potential with beginners to wrongly tie the bowline. This faulty knot stems from an incorrect first step while tying the rabbit hole. If the loop is made backwards so that the end of the rope (the bitter end) is on the bottom, the resulting knot will be sideways. The final loop of a sideways bowline will slip. This makes it particularly dangerous in the case of an inexperienced sailor, who, in addition to having an insecure knot, is also less familiar with what to do should it come untied on the water.

If a bowline is tied and the two free ends of the rope are brought together in the simplest way, the mathematical knot obtained is the so-called 6₂ knot. The sequence of necessary moves are depicted here:

• 
  From a bowline (ends connected) to the 6₂ knot.

As noted above, the simplicity of the bowline makes it a good knot for a general purpose end-of-line loop. However, in situations that require additional security, several variants have been developed:

Two-loop Birmingham bowline before tightening and dressing the knot. Two turns taken around the standing part of the line form two loops.

The cowboy bowline (also called Dutch bowline), French bowline, and Portuguese bowline are variations of the bowline, each of which makes one loop. (Names of knots are mostly traditional and may not reflect their origins.) A running bowline can be used to make a noose which draws tighter as tension is placed on the standing part of the rope. The Birmingham bowline has two loops; the working part is passed twice around the standing part (the "rabbit" makes two trips out of the hole and around the tree). Other two-loop bowline knots include the Spanish bowline and the bowline on the bight; these can be tied in the middle of a rope without access to the ends. A triple bowline is used to make three loops.[11] A Cossack knot is a bowline where the running end goes around the loop-start rather than the main part and has a more symmetric triangular shaped knot. A slipped version of the Cossack knot is called Kalmyk loop.[12][13]

• List of knots
• Karash double loop
• Eye splice

• Video of the Lightning Method
• Mark Gommers: An Analysis of Bowlines In-depth review of the bowline and its variants.
• YouTube animation of a Bowline knot