Curtain

From evidence found in excavation sites at Olynthus, Pompeii and Herculaneum, portieres, a curtain hung over a doorway, appear to have been used as room dividers in classic antiquity. Mosaics from the 2nd to 6th century show curtains suspended from rods spanning arches.[2]

Translucent curtains hung on a window.

Curtains are manufactured from a variety of thick fabrics, each with a differing degree of light absorption and heat insulating qualities. For maximum temperature control, the curtain gap to the window should be small, with minimum convection drafts below or above the curtain. Various architectural structures around the curtain can minimize these air drafts, but usually they are just used for decoration and make rooms feel more cozy.

A sheer or net curtain is one that is made from translucent fabric, such as a loosely woven polyester voile or a cotton lace. Sheer curtains allow a majority of light to be transmitted through the fabric, with the fabric weave providing a basic level of UV protection while retaining maximum visibility outward through the curtain. Sheer curtains are sometimes referred to as "privacy curtains" in reference to their screening abilities; during the day most sheer fabrics will allow people inside the home to see the outside view while preventing people outside the home from seeing directly into the home. Due to the loose weave in sheer fabrics, these types of curtains offer very little in the way of heat insulation.

Uncoated fabrics provide the next level of heat insulation and light absorption. Uncoated fabrics constitute the vast majority of fabrics used in curtains, and are composed of a tightly woven fabric, most typically a cotton/polyester blend, which is mostly opaque when viewed in ambient light. Uncoated fabrics provide a reasonable level of heat insulation due to the tight weave of the fabric. However, the fabric itself is typically not thick enough to completely absorb strong light sources. As a result, when curtains made from uncoated fabrics are closed in an attempt to block out direct sunlight, light will still be visible through the curtain.

A roll-down curtain

Coated fabrics consist of a standard uncoated fabric with an opaque rubber backing applied to the rear of the fabric to provide improved light absorption. To create a coated fabric, a liquefied rubber polymer is applied in a single coat to an uncoated fabric and subsequently fused dry by means of a heated roller, in much the same way that a laser printer applies toner to a sheet of paper before fusing it dry. A fabric that has been through the coating process once is considered a "1-pass-coated" fabric, anecdotally referred to as "dim-out" or "blackout" because of the fabric's ability to absorb approximately 50-70% of a direct light source. To improve the light absorption of a fabric it is possible to re-coat a fabric up to a maximum of "3-pass-coated", which is considered sufficient to block out 100% of a direct light source, hence such fabrics are referred to as "blockout-coated".

Maximum light absorption and heat insulation in a curtain is created through a lined curtain, which typically consists of an uncoated fabric at the front to provide the look and feel of the curtain, with a separate coated fabric attached at the rear to provide the insulative qualities. The coated fabric is typically referred to as a lining, which simply refers to a coated fabric that does not have any particular color or pattern.

Curtains may be held back with tie-backs (a loop of cloth, cord, etc., placed around a curtain to hold it open to one side; typically passed through a ring on a hook attached to the wall, and fastened with a knot, button, or velcro; often adorned with tassels) or may be closed and opened with sticks called draw-pulls (rods made of plastic, wood, or metal that can be twisted and/or pulled) or curtain rods which are attached either to the runner or to the first hook. On some curtain rails/poles, there is a pulley system for opening and closing called a "corded curtain track". The knobs at the end of these cords are called cord pulls or "acorns". A roll-down or drop-down curtain has its fabric rolled around the curtain rod and is lowered down from above by a separate device (such as pictured at right) or by pulling the fabric itself, with curtains using the latter mechanism being called pull-down curtains.

A curtain hook stopper is a device used to stop the curtain from falling off the end of the curtain rail.

Curtains in a window opening to the sea.

Curtains can be used to give a room a focal point. There are at least twenty different styles of curtains[6] and draperies which can be used in window treatment.

• Flat panel curtains are simple and versatile: to make them, pieces of fabric are hemmed on all four edges and the final rectangular or square piece is hung from curtains poles with clip-on rings or something similar.[6] If pleated, the look is strongly influenced by the fullness of the pleats.
• Panel Pair Curtains are also known as double panel curtains. They refer to two curtain panels hanging on either side of the window. This is the most common style.
• Tab top curtains are made with narrow straps, that loop or tie at the top edge and hung from the curtain pole.[7] This curtain style is often designed as two stationary panels at the sides of a window.
• Grommet curtains are hung by threading the curtain pole through a hole in the top of the fabric. This could be either a cut-out hole with the edges finished by a row of stitching or it could use a grommet to prevent fraying.
• Sash curtains are used to cover the lower sash of the windows.
• Rod pocket curtains have a channel sewn into the top of the fabric. A curtain rod is passed through the channel to hang.[8]
• Thermal or blackout curtains use very tightly woven fabric, usually in multiple layers. They not only block out the light, but can also serve as an acoustic or thermal dampener.
• Curtain liners are used to protect actual curtains from getting wet.
• Eyelet Curtains are attached to a pole (usually metal). A number of circular holes are cut into near the top of the curtain and edged with a metal ring (eyelet). The pole is then threaded through these holes, with approx. 4cm of fabric showing above the pole.
• Pencil Pleat Curtains are formed by pulling cords attached to "rufflette tape" to gather the fabric into pleats that look like a row of pencils. These curtains are then hung under a pole or attached to a curtain track with plastic hooks fitted in every 4th "pocket" along the rufflette heading. Typically a 1.5m width of fabric will be gathered to 750mm width. Rufflette Tape was originally developed from tape which held ammunition (bullets) for semi automatic machine guns.
• Pinch Pleat Curtains are usually formed by machine stitching together either 2 or 3 pleats, then leaving a gap of typically 10cm before repeating the pleating process. These curtains are then hung under a curtain pole using either metal pinch pleat hooks or vertical sliding plastic hooks sewn into the reverse of the pleats.

• Curtains
• 
  Chateaud Amboise
• 
  Austrian blinds
• 
• 
  Hotel Transvaal
• 
• 
  Waterfall curtain
• 
• 
  Main curtain used as a backdrop at a movie theater.
• 
  Noren (Japanese curtain) at an onsen.
• 
  Hotel bedroom
• 
  Bottle top curtain
• 
  Bedroom of Queen Charlotte Mathilde
• 
  Bed with baldachin
• 
  Bathtub with curtain at the Bernheimer House
• 
  Seashell curtain

• Curtain ring, curtain rod, curtain tie-back
• Theater drapes and stage curtains
• Front curtain
• Safety curtain
• Pipe and drape
• Kichō

• Media related to Curtains at Wikimedia Commons
• "Curtain" . Encyclopædia Britannica (11th ed.). 1911.