Enriched flour

White flour became adopted in many cultures because it was recognized as being healthier than dark flours during the late Middle Ages. The unknown factor for its benefit at that time was that mold and fungus in the grains, which led to several diseases, were eliminated in the processing that resulted in white flour.

In the 1920s, Benjamin R. Jacobs began to document the loss of essential nutrients, however, through this processing of cereals and grains and to demonstrate a method by which the end products could be enriched with the lost nutrients. These nutrients promote good health and help to prevent some diseases.

The international effort to start enriching flour was launched during the 1940s as a means to improve the health of the wartime populations of the British and United States while food was being rationed and alternative sources of the nutrients were scarce. The decision to choose flour for enrichment was based on its commonality in the diets of those wartime populations, ranging from the rich to the poor. A major factor in the switch to enriched flour in the United States was the U.S. Army's restriction in 1942, that it would purchase only enriched flour.

The conversion of grains to flour involves several steps that vary with the type of grain used. The initial stages of processing remove the bran and the germ of the seed. The bran is the outermost layer of grains that contains fiber (primarily insoluble), some protein, and trace minerals. The germ is the embryo of the seed that contains B vitamins and trace minerals. Because the germ has a fat content of 10%, it may reduce shelf-life. Thus, it is separated to ensure longer shelf life of the flour. In contrast to enriched flour, whole wheat flour contains both the bran and the germ. The remaining and largest portion of the seed is the endosperm. It acts as a nutrient reservoir for the developing embryo. The endosperm contains a large amount of carbohydrates, protein, iron, B vitamins (niacin and riboflavin), and soluble fiber.

Once the endosperm is isolated, it is ground into a fine powder and sifted to remove any remaining fragments of bran or germ. Next, a chemical bleaching process is used to give the flour a whiter color. This bleaching step, usually with chlorine or benzoyl peroxide, destroys many of the original nutrients that were present in the flour. The final flour product contains a smaller portion of the original nutrients that were present in the seed prior to processing. Enrichment ensures that these important nutrients are restored to improve the quality of the flour.

According to the U.S. FDA, a pound of enriched flour must have the following quantities of nutrients to qualify: 2.9 milligrams of thiamin, 1.8 milligrams of riboflavin, 24 milligrams of niacin, 0.7 milligrams of folic acid, and 20 milligrams of iron. The first four nutrients are B vitamins. Calcium also may be added; this must be to a minimum level of 960 milligrams per pound if calcium is mentioned in the labeling. Similar rules are set for grains like rice and maize.[2]

Other countries also have flour enrichment programs.[3]

• Iodised salt – which might be called "Fortified salt".
• Whole-wheat flour

1. "From Wheat to Bread". Canadian Wheat Board. Archived from the original on 2013-12-20. Retrieved 2013-08-17.
2. "Wheat Kernel Structure". Wheat Flour Book. Overview of U.S. Wheat Inspection. Retrieved 2013-05-20.
3. "Vitamins and Minerals". Grain Information Service. Archived from the original on 2012-04-25. Retrieved 2013-05-20.
4. Nystrom, J.L.; Sarkar, A.K.; Maberly, G.F. (2006). "17.2: Enriching Flour, Enriching Lives: The Flour Fortification Initiative" (PDF). In Popper, Lutz (ed.). Future of Flour (PDF). sec. "Flour Fortification". ISBN 978-3-86037-309-5. Retrieved 2013-05-20.