Tung Chung Road

Tung Chung Road (traditional Chinese: 東涌道; simplified Chinese: 东涌道; pinyin: Dōngchōng Dào; Cantonese Yale: dung1 chung1 dou6) is a two disjointed-section road connecting the north and south coast of Lantau Island.

Tung Chung Road
Tung Chung Road near Pak Kung Au
Route information
Maintained by Highways Department
Length8.0 km (5.0 mi)
RestrictionsAccess south of Shek Mun Kap require permit
Southern segment
Length7.3 km (4.5 mi)
South endSouth Lantau Road near Cheung Sha
Major
junctions
Shek Mun Kap Road near Fong Yuen
North endCul-de-sac in Tung Chung
Northern segment
Length0.7 km (0.4 mi)
South endCul-de-sac in Tung Chung
North endTung Chung Bay
Highway system

Description

The first section is a short road linking a former pier and Wong Nai Uk in Tung Chung. The second is a long and hilly section connecting Tung Chung in the island north to Cheung Sha in the island south. The two sections were previously connected until the completion of the replacement road, Chung Yan Road in Tung Chung New Town.

The short section is featured with historical Tung Chung Battery, a military coastal defence in Ming dynasty. It runs along the a river Ma Wan Chung and ends in Chung Yan Road.

The long section is a long, steep, narrow and winding road. Due to physical constraints, it was open only to buses, taxis and permit-bearing vehicles only and speed limit is set to 30 km/h. being too dangerous for double-decker buses to be trafficable and only "single-deckers" are used in the bus services. It starts near Ma Wan New Village and joins Chung Yan Road near a river before proceeding upwards to the valley between Sunset Peak and Lantau Peak. It reaches its highest point at a pass in Pak Kung Au (also known as Tung Chung Au) then follows a steep downhill route. The southern end joins South Lantau Road in Cheung Sha.

Because of its limited capacity, the Transport Department opened the road only to buses, taxis and holders of a permit, issued to residents and business of South Lantau.

The nature of Tung Chung Road helped preserve the rural landscape in southern Lantau. There are bus routes from Tung Chung to various destinations like Cheung Sha, Mui Wo, Shek Pik and Tai O in the island's south. The road splits off the Lantau Trail on the southern slope of the island.

History

Tung Chung Road and Pak Kung Au, in Tung Chung, Hong Kong. Sunset Peak is on the left and Lantau Peak is on the right.

New section

Prior to completion of the new section in 2009, numerous parts consisted of a single lane only; when two oncoming vehicles approached, one had to find a passing place to stop and let the other pass.

On 6 February 2009, the improved Tung Chung Road section between Lung Tseng Tau and Cheung Sha near San Shek Wan on Lantau Island was fully opened from 10am. The new road is a dual carriageway wide enough for two vehicles to pass each other and has fewer sharp turns.

Following the opening, the old road section between Pak Kung Au and Cheung Sha near Cheung Sha Bridge has been closed. Vehicles are diverted to the new road section between Pak Kung Au and San Shek Wan.[1]

Intersections

The entire route is in Islands District.

Locationkm[2][3]miDestinationsNotes
0.00.0South Lantau RoadRoundabout
Pak Kung Au2.61.6Old Tung Chung Road
2.81.7Old Tung Chung Road
4.02.5Old Tung Chung Road
5.43.4Shek Mun Kap Road
Tung Chung7.14.4Wong Lung Han Road
Chung Yan Road
7.24.5Pa Mei Road
7.34.5Cul-de-sac
Gap in route
Tung Chung7.34.5Cul-de-sac
7.44.6To Yat Yung Street / Chung Yan Road
8.05.0Tung Chung BayCul-de-sac
1.000 mi = 1.609 km; 1.000 km = 0.621 mi
  •       Closed/former

See also

References

  1. Improved Tung Chung Road to open Archived 2009-02-06 at the Wayback Machine
  2. OpenStreetMap contributors. Tung Chung Road (Southern segment) (Map). OpenStreetMap. Retrieved 29 June 2015.
  3. OpenStreetMap contributors. Tung Chung Road (Northern segment) (Map). OpenStreetMap. Retrieved 29 June 2015.
This article is issued from Wikipedia. The text is licensed under Creative Commons - Attribution - Sharealike. Additional terms may apply for the media files.