Jagdschloss radar

The PPI effort started fairly early in the history of radar; Hans Hollmann filed a patent for the basic concept in 1936. At that time development of GEMA's other radars, notably the Freya, took priority, and work on the system did not start until 1939. By this time, radar development had progressed to the point were a prototype could be constructed by re-using systems from various production radars.

A prototype system was built 35 km west of Berlin, known as the Tremmen Radar Tower. It mounted a large antenna consisting of two rows of four half-wave dipoles aligned horizontally, rotating on a shaft located at the top of the tower. It was found that at least five pulses needed to be returned in order for the target to become visible on the scope, so the rotation rate of the antenna was adjusted to synchronize with the pulse repetition frequency of the radar. The radio equipment was taken from the Wassermann and Freya units, and operated on a basic wavelength of 2.4 m (~125 MHz).

Although the system demonstrated its utility, further units were not ordered until the fall of 1942, likely due to the increasing tempo of RAF Bomber Command's night offensives at that time. Production Jagdschloss units were larger than the original prototype, with an antenna 24 m (79 ft) wide and 3 m (9.8 ft) tall. New electronics were built for the production units, operating on one of two bands, the A band on 1.2-1.9 m or the B band on 1.9-2.5 m. The first production sets were delivered by Siemens & Halske at the end of 1943, and when production ended in April 1945 a total of 80 units had been delivered.

Jagdschloss units were found to have several "dead spots" due to the antenna being located on an 8-metre-high (26 ft) tower. For instance, an aircraft flying at 6,000 m (20,000 ft) altitude at any range between 60–80 km (37–50 mi; 32–43 nmi) would be invisible because the direct reflection from the aircraft would interfere with the one reflecting off the ground. This problem was initially solved with the addition of a large wire mesh under the tower, known as Reflektor-Netz.

Erstling codegenerator

A more convincing solution to this problem was deployed as Jagdschloss Michael. Michael added a second antenna on the "back" of the original, operating on a 50 cm wavelength system from Telefunken (almost certainly adapted from their Würzburg radar). Range was also increased from the original 150–300 km (93–186 mi; 81–162 nmi), which required an improvement in the angular resolution in order to maintain the ability to resolve aircraft. To achieve this, Michael used a new 50-metre-wide (160 ft) antenna replacing the older 24 m one. The antenna was so large that the mounting had to be re-designed, with the antenna supported by rollers running in a track as opposed to being mounted off a central shaft.

Another cm-wavelength experiment was built at Werneuchen, east of Berlin, known as Jagdschloss Z. This system operated on a 9 cm wavelength, which was very short for the era. The antenna was built up from the center sections of the Würzburg radar's parabolic dish, stacked vertically to form a single 72-wavelength aperture antenna.

Jagdschloss units of all types were optionally fitted with the Erstling IFF system. Like British IFF units, Erstling fed back its own return upon reception of a Jadgschloss signal. The return signal was slightly delayed, appearing as a second "blip" on the radar screen, allowing the operator to visually identify friendly aircraft. Unlike British systems, Erstling apparently sent back a morse code signal in return.

The FuG25a "Erstling" had two encryption keys inside, each of 10 bits. One called "Reichskennung" and the other "Verbandskennung " (squadron key).

A related system, Jagdhütte (German: "hunting lodge"), is also mentioned in reference to Erstling. This was a reduced version of Jagdschloss without radar receiver, operating only with the IFF Signals from Erstling. This was for control of the Luftwaffe's own night fighters only. Due to the different transmit and receiving frequencies, it was resistant against Düppel interference.

Another optional system for use with Jagdschloss was a remote PPI display known as Landbriefträger (German: country mailman). This allowed the display from a Jadgschloss site to be sent via telephone lines to the flak defenses so they could arrange their attacks locally. Signals from the original Tremmen and the later Werneuchen radars were forwarded to the flak tower close by the Berlin Zoo.

Original Service Manual (115 pages)

• The document states that the Jagdschloss units worked in two bands in the description text, but in three bands in another part of the document. The third band is 2.4 to 4.0 m.
• The document's description of Jagdschloss Michael states the second signal was sent out of the back of the antenna, and operated on a 50 cm wavelength. However, the description is not entirely clear, and the difference in wavelengths would make this somewhat difficult to arrange. Generally the range of a 50 cm unit would also be shorter than longer wavelengths on the other side, due to limitations of the electronics of the era, but the document does not state if the range of this "side" of the system was any different.

• Development of the first PPI Radar (Funkmess-Uebersichstverfahren), Dr. Ing. Theodore Schultes, translated into English by Martin Hollmann
• Swords, Sean S., Technical History of the Beginnings of Radar, London: IEE/Peter Peregrinus, 1986. ISBN 0-86341-043-X.