Kongō-class destroyer

The JMSDF built JDS Amatsukaze (DDG-163) under FY1960 program and started shipboard operation of surface-to-air missiles. She had been equipped with analog-version of the Tartar Guided Missile Fire Control System.[2] A fully-digitized system was adopted on the next-generation Tachikaze class, and later a combat direction system based on the Naval Tactical Data System was added.[3]

Nevertheless, the JMSDF estimated that its fleets would not survive against Soviet airstrikes, especially Tupolev Tu-22M bombers and AS-4 air-to-surface missiles. Based on these estimates, JMSDF began to pursue the introduction of the Aegis Weapon System (AWS) from the early 1980s. In 1984, with the prospect of deploying AWS, concrete implementation plans began. And the construction of Japanese first Aegis-equipped ships, Kongo class, had begun under FY1988 program.[4]

The overall design is generally modeled on the Arleigh Burke-class destroyers of the U.S. Navy. The hull adopted shelter deck design as with preceding Japanese destroyers, but it was widened to support the superstructure with four PESA antennas just as Arleigh Burke class. Due to this widened hull, the outer panel is inclined to reduce the width of the waterline, which also has the effect of reducing radar cross section area.[5]

Because they are built to different operational requirements than the Arleigh Burke-class destroyers, such as for carrying extra commanding equipment, the Kongō-class ships' internal arrangement is quite different from the original design on which they are based. Recognisable external features are the vertical mast and enlarged superstructure to carry sufficient headquarters equipment so that they could act as a flagship.[5]

The propulsion systems are almost the same as those of the Arleigh Burke class, powered by four Ishikawajima-Harima LM2500 gas turbines giving them a top speed of 30 knots (56 km/h; 35 mph).[5][6]

The class is equipped with the Aegis Weapon System (AWS). The system version was Baseline 4 for name-ship through third ship, and Baseline 5 for fourth ships immediately after they were put into service; then all ships were updated to Baseline 5.3 with modernization. As surface-to-air missiles, The SM-2MR Block IIIA was initially used, and later the Block IIIB came into use. Since the mid-2000s, they have also been equipped with a missile defense capability with the primary intention of countering North Korean ballistic missiles, and now have an Aegis BMD 3.6 system installed to launch SM-3 Block IA and IB missiles.[5]

The Mark 41 Vertical Launching System arrangement, similar to the Arleigh Burke class, consisted of 29 cells on the foredeck and 61 cells on the afterdeck. These cells contain not only SM-2 and SM-3, but also VL-ASROCs.[6] In addition, they are equipped with HOS-302, one of the Japanese variant of the Mark 32 Surface Vessel Torpedo Tubes, as anti-submarine weapons and Harpoon as antiship missiles.[5] And as gunnery weapons, an Oto Melara 127 mm (5 in)/54 caliber gun and two Mark 15 20 mm CIWS gun mounts are installed.[5][6]

Most of electronic devices outside of AWS are originated in Japan. For electronic warfare, this class is equipped with NOLQ-2, an elaborate system capable of both ES and EA.[6] The OQS-102 sonar is equivalent to the U.S. SQS-53C.[6]

The Kongō-class destroyers are named after mountains in Japan, and all four also share their names with World War II era Japanese warships. Kongō and Kirishima share their names with two ships of the Kongō-class battlecruiser, while the other two ships share their names with the heavy cruisers Myōkō and Chōkai. G,Dreyfus

• Aegis Combat System
• List of naval ship classes in service
• List of active Japan Maritime Self-Defense Force ships

Wikimedia Commons has media related to Kongou class destroyers.

• GlobalSecurity.org; JMSDF DDG Kongo Class
• Japan Maritime Self-Defense Forces page on Andrew Toppan's Haze Gray and Underway web site