Toyota G engine

The Toyota Motor Corporation G-family engine is a family of straight-6 piston engines produced from 1979 to 2006. It is notable in that only a single displacement, 2.0 L (1,988 cc), was produced in this series. All were belt-driven OHC non-interference engines (except the VVT-i version in the Lexus IS200 which is an interference engine), with multivalve DOHC (except the 1G-EU SOHC 12 valve engine) and even variable valve timing added later. The 1G-GEU was Toyota's first four-valve twincam engine.[1] A prototype version of the 1G-GEU called the LASREαX, featuring twin-turbos, variable valve timing and intake as well as variable displacement, was fitted to the Toyota FX-1 show car at the 1983 Tokyo Motor Show. It showcased a number of technologies which were later to become commonplace.[2]

Toyota G engine
1G-GEU engine in a Toyota Supra GA61
Overview
ManufacturerToyota Motor Corporation
Production
  • 19671968
  • 19792005
Layout
ConfigurationStraight-6
Displacement2.0 L; 121.3 cu in (1,988 cc)
Cylinder bore75 mm (2.95 in)
Piston stroke75 mm (2.95 in)
ValvetrainSOHC 2 valves x cyl.
DOHC 4 valves x cyl.
with VVT-i (since 1998)
Combustion
SuperchargerIn 1G-GZE
TurbochargerCT-12 (in 1G-GTE)
Fuel systemFuel injection
Fuel typeGasoline
Cooling systemWater-cooled
Output
Power output100–210 PS (74–154 kW; 99–207 hp)
Torque output152–275 N⋅m (112–203 lb⋅ft; 15–28 kg⋅m)

These engines were used as a lower-displacement alternative to the more upmarket M family and JZ family straight-sixes.

For ten months (in 1967-1968), Toyota also offered Hino's GR100 engine as the "Toyota G" in the shortlived Briska light truck.[3]

G (Hino GR100)

After Toyota's takeover of Hino Motors in 1967, the Briska one-tonne truck was sold with Toyota badging for ten months. The engine code was changed from Hino's "GR100" to "G" for these cars.[4] The engine is a 1251 cc watercooled OHV inline-four with distant Renault origins and was originally developed by Hino for their Contessa passenger car. Bore and stroke are 71 mm × 79 mm (2.80 in × 3.11 in), maximum power 63 PS (46 kW) at 5500 rpm. Hino's earlier models had a variety of power outputs ranging from 52 to 65 PS.

Apart from its name, this engine is unrelated to the later series of Toyota G engines.

1G

Since just one displacement was offered, all G-family engines are marked 1G and share the same "square" 75 mm (2.95 in) bore and stroke.

Applications:

1G-E

The export-spec two-valve 1G-E had no emissions controls and were used in commercial vehicles and for a few export markets, mostly southeast Asia. Typical specifications:

  • 80 kW (109 PS; 107 hp) at 5000 rpm, 162 N⋅m (119 lb⋅ft) torque at 4000 rpm (Mark II, 1986, Indonesia)
  • 100 PS (74 kW; 99 hp) at 5200 rpm, JDM Crown GS130/131/136V/130G

1G-EU

The Japan-spec 1G-EU was produced from 1979 through 1988. This and the 1G-E are the only two-valve SOHC members of the family. Output was 105–125 hp (78–93 kW; 106–127 PS) at 5400 rpm and 157–172 N⋅m (116–127 lb⋅ft) at 4400 rpm.

1G-FE

1G-FE

The DOHC 1G-FE uses a narrow valve angle and other fuel economy optimizations. It was introduced in 1988, it features a cast iron block with aluminum cylinder head. Output was 135 PS (99 kW; 133 hp) at 5,600 rpm and 176 N⋅m (130 lb⋅ft) at 4,400 rpm. In 1998 VVT-i was added, which bumped output to 160 PS (118 kW; 158 hp) at 6,200 rpm and 200 N⋅m (148 lb⋅ft) at 4,400 rpm for the Altezza/IS 200. With the end of the first generation Lexus IS this engine ceased production in 2005.

Applications:

1G-GEU

The 24-valve DOHC 1G-GEU was intended for high performance and featured a pent-roof combustion chamber.[5] Introduced in August 1982 and produced through 1986, mostly for the Japanese market, output was 140–160 PS (103–118 kW; 138–158 hp) at 6,200 rpm and 162–181 N⋅m (119–133 lb⋅ft) at 5,600 rpm. This was Toyota's first multi-valve twincam engine to make it to the market, and won the "JSME Medal for New Technology" (Japan Society of Mechanical Engineers) in 1982. To minimize the downsides of a multi-valve setup, the 1G-GEU was also equipped with T-VIS (Toyota Variable Induction System), increasing low to mid-engine speed torque. Like all following twin cam Toyotas, it used a timing belt rather than chain, for less noise and lower maintenance requirements. In August 1983, the fuel injection system was changed to EFI-D, which measures the pressure in the intake manifold to determine the proper air-fuel mixture.[1][6]

Applications:

1G-GE

The 1G-GE replaced the 1G-GEU in 1988. It was detuned from 160 hp (119 kW; 162 PS) down to 150 hp (112 kW; 152 PS) and served the same cars as 1G-GEU did. It was produced for the Supra GA70 until 1993.

1G-GTE

Toyota 1G-GTE

The 24-valve DOHC 1G-GTE added two CT-12 turbochargers to the versatile motor. There were 3 generations of this engine both air-to-air and air-to-water intercoolers were used, pushing output from 185 to 210 PS (136 to 154 kW; 182 to 207 hp) at 6200 rpm and 234 to 275 N⋅m (173 to 203 lb⋅ft) at 3800 rpm using the air-to-air over the air-to-water. This was the most powerful engine of the whole G family. In May 1991 it was replaced with the 280 PS 1JZ-GTE on most Toyota cars.

Applications:

1G-GP/GPE

The 1G-GP and 1G-GPE was an LPG version of the 1G-GE engine. Output is 110 PS (81 kW; 108 hp) at 5600 rpm and torque is 15.5 kg⋅m (152 N⋅m; 112 lbf⋅ft) at 2400 rpm.[7]

Applications:

  • Toyota Crown sedan (GS130)
  • Toyota Crown Comfort[7]

1G-GZE

The 1G-GZE was a supercharged version produced from 1986 till 1992. Output is 170 PS (125 kW; 168 hp) at 6000 rpm and 226 N⋅m (167 lb⋅ft) at 3600 rpm. Like the turbo, it was a 24-valve DOHC engine but featured a distributorless ignition system (DIS). The 1G-GZE was mated only with automatic gearboxes. In August 1991 it was replaced with the 1JZ-GE on the Mark II/Chaser/Cresta, while serving on the Crown until 1992.

Applications:

  • Toyota Crown GS120, GS121, GS131, GS130G (Station Wagon)
  • 19881990 Toyota Mark II/Chaser/Cresta GX81

References

  1. All About the Toyota Twin Cam, 2nd ed., Tokyo, Japan: Toyota Motor Company, 1984, p. 9
  2. All About the Toyota Twin Cam, p. 18
  3. 日野のクルマ:カタログよりトヨタ・ブリスカ [Hino cars: Toyota Briska catalog]. Hino Samurai (in Japanese). Satoshi Ezawa. Archived from the original on 2016-09-19.
  4. "ブリスカ" [Briska]. 75 Years of Toyota - Vehicle Lineage (in Japanese). Toyota. Archived from the original on 2016-07-08.
  5. All About the Toyota Twin Cam, p. 21
  6. All About the Toyota Twin Cam, p. 20
  7. "Crown Comfort" (brochure). Dec 1995. p. 17. Retrieved 3 June 2013.

See also

This article is issued from Wikipedia. The text is licensed under Creative Commons - Attribution - Sharealike. Additional terms may apply for the media files.