Quantum illumination

The concept of quantum illumination was first introduced by Seth Lloyd and collaborators at MIT in 2008.[2][3] A theoretical proposal for quantum illumination using Gaussian states[4] was proposed by Jeffrey Shapiro and collaborators.[3]

The basic setup of quantum illumination is target detection. Here the sender prepares two entangled systems, called signal and idler. The idler is retained while the signal is sent to probe the presence of a low-reflectivity object in a region with bright background noise. The reflection from the object is then combined with the retained idler system in a joint quantum measurement providing two possible outcomes: object present or object absent. More precisely, the probing process is repeated many times so that many pairs of signal-idler systems are collected at the receiver for the joint quantum detection.

The advantage of the scheme is evident at low energies where the mean number of photons in each signal system is very low (of the order of one photon or less). In this case, at fixed low energy, the probability of success in detecting a target has a remarkable improvement with respect to classical detection schemes, where entanglement is not used and signal systems are prepared in coherent states (technically, there is a 6 dB improvement in the error exponent [3]). A key feature of quantum illumination is that the entanglement between the idler system and the reflected signal system is completely lost in the process. However, the residual quantum correlations between these two systems (idler-reflected signal) remain so strong that they could only be created by the presence of entanglement in the initial systems (idler-signal). Because the reflected signal is quantum-correlated with the retained idler system, it can be distinguished among all the uncorrelated background thermal photons that are also received by the detector. Because of this quantum labeling of the systems, the detection of quantum illumination is very efficient.

In 2015, an international collaboration coordinated by Stefano Pirandola [5][6] extended the protocol of quantum illumination to the microwave frequencies, thus providing the first theoretical prototype of quantum radar.

The original proposal from [3] was analyzed in the Bayesian setting of hypothesis testing, in which prior probabilities are assigned to the hypotheses that the target is absent or present. In 2017, a research paper[7] analyzed quantum illumination in the Neyman-Pearson or asymmetric setting of hypothesis testing, which is a setting of interest in quantum radar applications. It was found that the performance gains of quantum illumination are even greater than those from.[3]

In 2017, an optimum receiver design was proposed by Quntao Zhuang, Zheshen Zhang, and Jeffrey Shapiro.[8] Quantum illumination has also been extended to the scenario of target fading.[9]

In 2009, a secure communication scheme based on quantum illumination[10] was proposed. This scheme is a variant of the quantum cryptographic protocols based on continuous variables and two-way quantum communication introduced by Stefano Pirandola, Seth Lloyd and collaborators[11] in 2008.

In 2013, Lopaeva et al. exploited photon number correlations, instead of entanglement, in a sub-optimal target detection experiment.[12] To illustrate the benefit of quantum entanglement, in 2013 Zhang et al. reported a secure communication experiment based on quantum illumination and demonstrated for the first time that entanglement can enable a substantial performance advantage in the presence of quantum decoherence.[13] In 2015, Zhang et al. applied quantum illumination in sensing and showed that employing entanglement can yield a higher signal-to-noise ratio than the optimal classical scheme can provide, even though the highly lossy and noisy environment completely destroys the initial entanglement.[14][15] This sensing experiment thus proved the original theoretical proposals of quantum illumination. The first experimental effort to perform microwave quantum illumination was based on using Josephson parametric amplifier and a digital receiver.[16][17] In 2019, Defienne et al. reported the first full-field imaging system based on quantum illumination that uses spatially-entangled photon pairs for imaging through noise.[18]