Gen4 Energy

According to Hyperion, the uranium nitride fuel incorporated in the design is generally similar in physical characteristics and neutronics to the standard ceramic uranium oxide fuel that is used at present in modern light water nuclear reactors. However, it has certain beneficial traits - higher thermal conductivity - and thus less retained heat energy - that make it preferable over oxide fuels when used at temperature regimes that are greater than the 250 to 300 °C (482 to 572 °F) temperatures found in light water reactors.[6] By operating at higher temperatures, steam plants can operate at a higher thermal efficiency. The presentation by Hyperion at the ANS 2009 conference mentions the use of the Doppler inherent negative temperature coefficient of reactivity in this reactor as a means of control.[7] Nuclear scientist Alexander Sesonske avers that nitride fuels have both received very little development (as of 1973) and seem to have a very favorable combination of physical properties - especially in fast reactors.[8] Whether this carries over to lead-bismuth cooled reactors is a question not answered in the reviewed literature, though the Soviet Union has worked with this type of reactor before in naval service; in particular, the Alfa class submarine - well known in the West for its high speed operation - was driven by such a lead-bismuth reactor which is known to have worked very effectively.[6]

The Hyperion module has sufficient fuel for 3650 full power days at 70 MWth, is capable of load following, and is meant to be built in pairs; one module can be at power, while another can be under installation or uninstallation at the same time, ensuring reliable supply of electricity.[6]

Hyperion plans to use natural circulation of the lead-bismuth coolant through the reactor module as a means of primary cooling. Coolant temperatures within the primary loop should be approximately 500 °C (932 °F). Powered intermediate heat exchangers, also using lead-bismuth coolant, are located within the reactor and run an intermediate loop going to a third ex-reactor heat exchanger (the steam generator), where heat is transferred to the working fluid, heating it to approximately 480 °C (896 °F). Two schemes of power generation exist at this point: either using superheated steam or supercritical carbon dioxide to drive Rankine cycle or Brayton cycle turbines. In addition to the classical use of power generation, further uses for the heated working fluid can include desalinization, process heat, and district heating and cooling.

The thermal hydraulics of the lead-bismuth reactor are dictated by the high heat capacity and unique properties of the lead-bismuth eutectic coolant. This coolant has several extremely beneficial properties for a reactor: it is opaque to gamma radiation, but transparent to neutron flux; it melts easily at a low temperature, but does not boil until an extremely high temperature is reached; it does not greatly expand or contract when exposed to heat or cold; it has a high heat capacity; it will naturally circulate through the reactor core without pumps being required - whether during normal operation or as a means of residual decay heat removal; and it will solidify once decay heat from a used reactor has dropped to a low level.[6]

Hyperion intends to pursue the licensing of the uranium nitride, lead-bismuth small reactor with the U.S. Nuclear Regulatory Commission (NRC), though the firm's deployment schedule (the target date for deployment was for the end of 2013) as well as indications from senior personnel within Hyperion indicates that perhaps the reactor will bypass the normal lengthy NRC process for commercial reactors and will instead be initially deployed by the U.S. Department of Energy or the U.S. Department of Defense, not subject to NRC regulation, or that Hyperion will seek a 10CFR50.21 Class 104 Research and Development reactor license from the NRC.[6] As of May 2010 Hyperion expects to apply to the NRC for regulatory approval "within a year."[9]

Possibilities for manufacture in nations other than the United States have also been mentioned as a way to overcome the NRC's lesser agility in responding to the commercial introduction of unique and innovative features of this reactor design. In particular, Hyperion plans to manufacture reactors in the United Kingdom, which has demonstrated recent national leadership in the field of nuclear energy, while a yet to be announced nation in Asia is targeted for manufacture as well.[6]