National Cycle Route 70

National Cycle Network (NCN) Route 70 is a Sustrans National Route that runs from Walney Island in Cumbria to Sunderland. The route is fully open and signed. From end to end the route is 149 miles (240 km),[1] but two sections are shared with other NCN routes leaving Route 70 at 128 miles (206 km).[2]

History

Route 70 is the original route of the W2W challenge route which was launched on 1 June 2005. When launched the route used sections of NCN Routes 72, 68 and 71 west of the Pennines. From Tan Hill to Sunderland a new Regional Route was created and given the number 20, with a blue background. In 2012, after improvements to meet National Cycle Network standards, it was upgrade to Route 70. Route signs were changed to the number 70 with a red background.[3] Around the same time the sections on the route that had previously been Route 71 and 72 were re-signed as Route 70.

Route

National Cycle Route 70
0
Walney Island
1
Route 700 leaves to E
2
Barrow in Furness
13
Ulverston
14
Route 700 joins from E
25
Cartmel
25
Route 700 leaves to E
27
Route 700 joins from E
27
Grange-over-Sands
36
Route 700 leaves to S
38
Route 6 joins from S
40
Route 6 leaves to N
41
Oxenholme
51
Route 68 joins from S
61
Orton
68
Routes 68 and 71 leave to N
74
Kirkby Stephen
80
85
Tan Hill, 530 metres (1,740 ft)
Route 71 leaves to S
93
Bowes
101
Barnard Castle
101
Routes 165 and 715 leave to S
115
Hamsterley
Bishop Auckland
124
Route 715 from S
131
Route 14 joins from N
131
Durham
137
Route 14 leaves to S
147
Sunderland
MeetsRoute 1
Sunderland
Route 1 to N

Walney to Oxenholme

The eastern section is 41 miles (66 km). From Walney Island in the Irish Sea (54.1026°N 3.2627°W / 54.1026; -3.2627 (Route 70 cycle route (western end))) it goes on to the industrial port of Barrow-in-Furness. It then runs through the Furness peninsula, passing the towns of Ulverston and the picturesque Grange-Over-Sands where the route follows the Promenade.[4] The route continues to skirt the Lake District national park to Oxenholme, with a short branch from there to the historical market town of Kendal

Oxenholme to Barnard Castle

The central sestion is 60 miles (97 km). On reaching the Lune Valley the route joins the Pennine Cycleway (Route 68) and is signed accordingly from there for the 17 miles (27 km) miles to Asby. After this, the path continues as Route 70 moving in an easterly direction towards Kirkby Stephen and through the Pennines to Barnard Castle in County Durham. The highest point on the route is at Tan Hill, 530 metres (1,740 ft).[5]

Barnard Castle to Sunderland

The eastern section is 49 miles (79 km). Continuing through Hamsterley, to reach the beautiful cathedral city of Durham. Regional Route 715 between Barnard Castle and Willington is an alternative W2W route, it is 2 miles (3.2 km) shorter and an easier ride via Bishop Auckland.[6] From Durham the route joins Route 14 for 6 miles (9.7 km) until Sherburn from where it continues is via Hetton Lyons Park to its eastern trailhead at Silksworth, Sunderland where it meets Route 1.

Route 70 meets the following routes:


Route 70 is part of the W2W along with:[7]

Route 70 is part of the Bay Cycle Way along with:[8]

Footnotes

  1. Walney to Wear cycle route map : the official route map & guide to the 151 mile cycle route between Barrow-in-Furness and Sunderland. [Bristol]: Sustrans. 2005. ISBN 1871149762.
  2. "Route 70 - Map". Sustrans. Retrieved 19 February 2018.
  3. "W2W renumbered to Route 70 / 165". W2W cycle route. Retrieved 23 January 2018.
  4. "W2W — Grange Promenade now open for cycling". cyclingw2w.info.
  5. "W2W — Route Map". cyclingw2w.info. Retrieved 19 February 2018.
  6. "W2W — Route Map". cyclingw2w.info. Retrieved 19 February 2018.
  7. "Walney to Wear [and Whitby] (W2W) - Map". Sustrans. Retrieved 19 February 2018.
  8. "The Bay Cycle Way - Map". Sustrans. Retrieved 19 February 2018.

This article is issued from Wikipedia. The text is licensed under Creative Commons - Attribution - Sharealike. Additional terms may apply for the media files.