Traffic calming

Engineering measures involve physically altering the road layout or appearance to actively or passively retard traffic by one of several means:

• increasing the cognitive load of driving (making driving more difficult)
• increasing the chance that an obstruction in the road will slow or momentarily stop motorists (such as replacing a bus pullout with a bus bulb, causing transit vehicles to stop for passenger loading and unloading in the travel lane, rather than pulling off and letting cars pass)
• increasing the chance of passenger discomfort or even physical damage to a vehicle if speed limits are not observed (such as speed humps).

Measures include speed humps, chicanes, kerb extensions, modal filters, and living street and shared space type schemes. The town of Hilden in Germany has achieved a rate of 24% of trips being on two wheels, mainly via traffic calming and the use of 30 km/h or 20 mph zones.[5] In 1999, the Netherlands had over 6000 woonerven where cyclists and pedestrians have legal priority over cars and where a motorised "walking speed" limit applies.[6] However, some UK and Irish "traffic calming" schemes, particularly involving road narrowings, are viewed as extremely hostile and have been implicated directly in death and injury to cyclists and pedestrians.[7][8]

A number of visual changes to roads are being made to encourage more attentive driving, reduced speed, reduced crashes, and a greater tendency to yield to pedestrians. Visual traffic calming includes lane narrowings (9-10'), road diets (reduction in lanes), use of trees next to streets, on-street parking, and buildings placed in urban fashion close to streets.

Physical devices include speed humps, speed cushions and speed tables, sized for the desired speed. Such measures normally slow cars to between 10 and 25 miles per hour (16 and 40 km/h). Most devices are made of asphalt or concrete but rubber traffic calming products are emerging as an effective alternative with several advantages.

Traffic calming can include the following engineering measures, grouped by similarity of method:[9]

• Narrowing: Narrowing traffic lanes makes slower speeds seem more natural to drivers and are less intrusive than other treatments that limit speed or restrict route choice. Narrowing measures include:
  • Lane narrowings can be created by extending sidewalks, adding bollards or planters, or adding a bike lane or on-street parking.[10]
  • Kerb extensions (also called bulbouts) narrow the width of the roadway at pedestrian crossings
  • Chokers are kerb extensions that narrow roadways to a single lane at certain points[11]
  • Road diets remove a lane from the street. For example, allowing parking on one or both sides of a street to reduce the number of driving lanes.
  • Pedestrian refuges or small islands in the middle of the street can help reduce lane widths.
  • Converting one-way streets into two-way streets forces opposing traffic into close proximity, which requires more careful driving.

Construction of polymer cement overlay to change asphalt to brick texture and colour to indicate a high-traffic pedestrian crossing.

• Vertical deflection: Raising a portion of a road surface can create discomfort for drivers travelling at high speeds. Both the height of the deflection and the steepness affect the severity of vehicle displacement. Vertical deflection measures include:
  • Speed bumps, sometimes split or offset in the middle to avoid delaying emergency vehicles
  • Speed humps, parabolic devices that are less aggressive than speed bumps.
  • Speed cushions, two or three small speed humps sitting in a line across the road that slow cars down but allows wider emergency vehicles to straddle them so as not to slow emergency response time.
  • Speed tables, long flat-topped speed humps that slow cars more gradually than humps
  • Raised pedestrian crossings, which act as speed tables, often situated at junctions.
  • Speed dips, sunken instead of raised (often seen as double dips in cycleways in The Netherlands)
  • Changing the surface material or texture (for example, the selective use of brick, cobblestone, or polymer cement overlay).

Changes in texture may also include changes in color to highlight to drivers that they are in a pedestrian-centric zone.

• • Rumble strips, when placed perpendicular to traffic in the travel lane (rather than placed between lanes parallel to traffic) act as speed bumps as they produce unpleasant sounds and vibration when crossed at higher speeds.
• Horizontal deflection, i.e. make the vehicle swerve slightly. These include:
  • Chicanes, which create a horizontal deflection that causes vehicles to slow as they would for a curve.
  • Pedestrian refuges again can provide horizontal deflection, as can kerb extensions and chokers.
• Block or restrict access. Such traffic calming means include:
  • Median diverters to prevent left turns or through movements into a residential area.
  • Converting an intersection into a cul-de-sac or dead end.
  • Boom barrier, restricting through traffic to authorised vehicles only.
  • Closing of streets to create pedestrian zones.
• Other means

Quite often residents have used a variety of homemade devices ranging from faux enforcement camera signs and even faux speed cameras and including dummy police. Some Canadian communities erect flexible bollards in the middle of the street in school zones. The bollards have a sign affixed indicating a 40 km/hr speed limit.

Enforcement and education measures for traffic calming include:

• Reducing speed limits near institutions such as schools and hospitals (see below)
• Vehicle activated sign, signs which react with a message if they detect a vehicle exceeding a pre-determined speed.
• Embedded pavement flashing-light systems which react to pedestrian presence at crossings to signal drivers and increase awareness.
• Watchman, traffic calming system

Speed reduction has traditionally been attempted by the introduction of statutory speed limits. Traffic speeds of 30 km/h (20 mph) and lower are said to be more desirable on urban roads with mixed traffic.[12] The Austrian city of Graz, which has achieved steady growth in cycling, has applied 30 km/h limits to 75% its streets since 1994.[13] Zones where speeds are set at 30 km/h (or 20 mph) are gaining popularity [14] as they are found to be effective at reducing crashes and increasing community cohesion.[15] Speed limits which are set below the speed that most motorists perceive to be reasonable for the given road require additional measures to improve compliance. Attempts to improve speed limit observance are usually by either education, enforcement or road engineering. "Education" can mean publicity campaigns or targeted road user training.

Speed limit enforcement techniques include: direct police action, automated systems such as speed cameras or vehicle activated signs or traffic lights triggered by traffic exceeding a preset speed threshold. One cycling expert argues for placing direct restrictions on motor-vehicle speed and acceleration performance.[16] An EU report on promoting walking and cycling specifies as one of its top measures comprehensive camera-based speed control using mainly movable equipment at unexpected spots.[17] The Netherlands has an estimated 1,500 speed/red-light camera installations and has set a target for 30 km/h limits on 70% of urban roads. The UK has more than 6,000 speed cameras, which took more than £100 million in fines in 2006/07.[18]

Traffic calming has been successfully used for decades in cities across Europe. For example, a living street (sometimes known as home zones or by the Dutch word woonerf, as the concept originated in the Netherlands) towards the end of the 1960s, initially in Delft, is a street in which the needs of car drivers are secondary to the needs of other road users; traffic calming principles are integrated into their design. From the Netherlands, the concept spread rapidly to Germany, starting in North Rhine-Westphalia in 1976, and had become very widespread by the early 1980s. The ideas and techniques also spread to the UK towards the end of the 1980s, and practice there was advocated by academics such as Tim Pharaoh and Carmen Hass-Klau. The guidelines published by Devon County Council (of which Tim Pharaoh was the principal author) in 1991 were particularly well received.[19]

Modal filter as part of a trial LTN in Kingston, London

In the United Kingdom, Low Traffic Neighbourhoods incorporate traffic calming and filtered permeability. In 2020, some LTNs were introduced with emergency funding from the government,[20] in response to the COVID-19 pandemic.[21]

More recently, in response to growing numbers of traffic accidents and speeding problems, cities across North America have begun creating traffic calming programs to improve safety and liveability on residential streets. Many municipalities create asphalt or concrete measures, although preformed rubber products that are easier to install and consistently meet standardized requirements are becoming increasingly popular. By 2017, San Francisco's Vision Zero program, which heavily features traffic calming, has reduced fatalities by 33%.[22]

A 2018 study found that traffic calming measures in Portland reduced excessive speeds, reduced daily traffic volume by 16% and increased home prices by 1%.[23]

Example of Traffic Calming in Oakland, CA

The Harrison and 23rd Street Crash Response Project was proposed by the Oakland Department of Transportation (OakDOT) in June 2017 after the death of 68-year-old Oakland resident Robert Bennett (Ferrara 2017).

68-year-old pedestrian Robert Bennett was killed by an unidentified driver turning left from 23rd Street onto Harrison Street (Tolan 2017). The accident was indicative of inadequate safety measures to protect pedestrian at the intersection, especially considering that Harrison Street runs adjacent to Oakland's largest senior center.

In response to the fatality and the subsequent protests by Walk Oakland Bike Oakland, Oakland's Department of Transportation (OakDOT) committed to make Harrison Street more conducive to pedestrians (Tadayon 2017). With a Traffic Engineering Technical Assistance Program grant from the Metropolitan Transportation Commission, the City of Oakland implemented changes that were part of the Vision Zero immediate crash response initiative. Harrison Street was historically a high injury corridor with a concentration of severe traffic-related collisions with “1.8 KSI (kills & serious injuries) per mile” and high speeds with 60% of vehicles over the legal limit (Harrison & 23rd St Crash Response). This problem was exacerbated by the six lanes of traffic on Harrison Street.

In addition to eliminating the left turn from 23rd Street onto Harrison Street, OakDOT's traffic calming scheme notably reduced the number of lanes on Harrison St from six to four. In place of the omitted lanes of traffic, OakDOT elected to add bicycle lanes in each direction and larger median (Harrison & 23rd St Crash Response). The revised median protects pedestrians by giving them more space to stand and added protection from permanent bollards while incorporating curbed ramps to ensure that they can be used by individuals with wheelchairs and strollers. Moreover, bulb-outs were added on each corner of the intersection to slow traffic while protecting pedestrians by reducing the amount of roadway they must cross. The enlarged median and bulb-outs were also painted bright purple making it more visible to drivers with the intention of reducing confusion and effectively making the intersection safer for pedestrians.

Since July 2017, OakDOT added to the original edition of the initiative. The revised edition, supported by the Lakeside Family Streets project and completed in 2019, replaced on street parking on Harrison Street between 20th Street to 27th Street with protected bike lanes. In conjunction with the additional bike lanes, the plan includes protected intersections for cyclists along Harrison Street to omit the need for dangerous mixing zones.

Various forms of traffic calming are used in Japanese cities, particularly in large cities like Tokyo and Yokohama. Tokyo's narrow streets force automobiles and pedestrians to be close to one another; a common traffic calming technique in Tokyo is to change the surface material and/or texture of the shoulder of narrow roads,[24] which helps define the boundary between cars and pedestrians, while allowing cars to use those spaces to pass oncoming traffic.